Quadra-Fire QV-PIER, QV-ST owner manual Safety and Warning Information, Prohibited

Page 2
Safety and Warning Information

Safety and Warning Information

READ and UNDERSTAND all instructions carefully

!before starting the installation. FAILURE TO FOLLOW these installation instructions may result in a possible fire hazard and will void the warranty.

!Prior to the first firing of the fireplace, READ the Using Your Fireplace section of the Owners Guide.

DO NOT USE this appliance if any part has been

!under water. Immediately CALL a qualified service technician to inspect the unit and to replace any part of the control system and any gas control which has been under water.

!THIS UNIT IS NOT FOR USE WITH SOLID FUEL. Installation and repair should be PERFORMED by a

!qualified service person. The appliance and venting system should be INSPECTED before initial use and at least annually by a professional service person. More frequent cleaning may be required due to excessive lint from carpeting, bedding material, etc. It is IMPERATIVE that the unit’s control compartment, burners, and circulating air passageways BE KEPT CLEAN to provide for adequate combustion and ventilation air.

Always KEEP the appliance clear and free from

!combustible materials, gasoline, and other flammable vapors and liquids.

!NEVER OBSTRUCT the flow of combustion and ventilation air. Keep the front of the appliance CLEAR of all obstacles and materials for servicing and proper operations.

Due to the high temperature, the appliance should

!be LOCATED out of traffic areas and away from furniture and draperies. Clothing or flammable material SHOULD NOT BE PLACED on or near the appliance.

!Children and adults should be ALERTED to the hazards of high surface temperature and should STAY AWAY to avoid burns or clothing ignition. Young children should be CAREFULLY SUPERVISED when they are in the same room as the appliance.

These units MUST use one of the vent systems

!described in the Installing the Fireplace section of the Installers Guide. NO OTHER vent systems or components MAY BE USED.

This gas fireplace and vent assembly MUST be

!vented directly to the outside and MUST NEVER be attached to a chimney serving a separate solid fuel burning appliance. Each gas appliance MUST USE a separate vent system. Common vent systems are

PROHIBITED.

INSPECT the external vent cap on a regular basis to

!make sure that no debris is interfering with the air flow.

!The glass door assembly MUST be in place and sealed, and the trim door assembly MUST be in place on the fireplace before the unit can be placed into safe operation.

DO NOT OPERATE this appliance with the glass

!door removed, cracked, or broken. Replacement of the glass door should be performed by a licensed or qualified service person. DO NOT strike or slam the glass door.

!The glass door assembly SHALL ONLY be replaced as a complete unit, as supplied by the gas fireplace manufacturer. NO SUBSTITUTE material may be used.

!DO NOT USE abrasive cleaners on the glass door assembly. DO NOT ATTEMPT to clean the glass door when it is hot.

Turn off the gas before servicing this appliance. It is

!recommended that a qualified service technician perform an appliance check-up at the beginning of each heating season.

!Any safety screen or guard removed for servicing must be replaced before operating this appliance.

!DO NOT place furniture or any other combustible household objects within 36 inches of the fireplace front.

2

Quadra-FireQV-PIER, QV-ST Series: HV-IPI2005-901 Rev. G • 2/06

Image 2
Contents Models QV-Pier QV-ST Series HV-IPI What to do if you smell gasSafety and Warning Information PROHIBITEDTable of Contents 6 Log Assembly Service Parts ListQV-Pier-HV-IPI COMMON PART ACCESSORIESQV-PIER-HV-IPI SERIAL #QV-ST-HV-IPI Service Parts11710 NG, LP Exploded Parts DiagramQV-ST-HV-IPI QV-ST-HV-IPI Service PartsQV-PIER-HV-IPI High Altitude Installations 1Approvals and CodesInstallation Codes Appliance CertificationIntroducing the Quadra-FireGas Fireplaces 2Getting StartedPre-installPreparation Diagram of the QV-PIER-HV-IPI TOP STANDOFFS GAS LINE ACCESSELECTRICAL ACCESS REAR VENT3Installing the Fireplace Step 1. Locating the FireplaceStep 2. Framing the Fireplace 35-3/4 ModelQV-PIER-HV-IPI QV-ST-HV-IPINOTE PIPES OVERLAP 1-1/4INCHES AT EACH JOINT DVP90STTEMS OR COMPONENTS MAY BE USED Step 3. Installing the Vent SystemA. Vent System Approvals Identifying Vent ComponentsFlue Restrictor Instructions Figure 13. Venting with One 90 Elbow Figure 14. Venting with One 90 ElbowFigure 15. Venting with Two 90 Elbows Venting with Two 90 Elbows Figure 17. Venting with Two 90 ElbowsFigure 18. Venting with three 90 elbows Figure 19. Venting with three 90 elbows B. Installing Vent Components Venting Out Vertically2. Continue Adding Vent Components Figure 25 Hole & New Framing Members = VENT TERMINAL = AREA WHERE TERMINAL IS NOT PERMITTEDFigure 29. Vent Termination Minimum Clearances X = AIR SUPPLY INLETMark the roof hole accordingly Step 5. The Gas Control System Propane PressureNatural Gas 5.0 inchesOperation using Battery Power Step 8. Wiring the FireplaceFor Intermittent Pilot Ignition Wiring Appliance RequirementsFan Installation Figure 35. Fan Wiring DiagramOptional Accessories Wall SwitchFigure 40. Sealant Material Hearth Extensions Step 9. FinishingIN ANY MANNER ANDIRON TABS 1/2”ANDIRONS Page Figure 53. Placement of the Ember Material Placing the Ember MaterialStep 12. Lighting the Fireplace After the InstallationStep 11. Before Lighting the Fireplace 4Maintaining and Servicing Your Fireplace Fireplace MaintenancePossible Causes 5 TroubleshootingSymptom Corrective ActionsPossible Causes SymptomIntellifire Ignition System - continued Corrective ActionsTHREE YEAR WARRANTY Lifetime WarrantyLIMITED LIFETIME WARRANTY TWO YEAR WARRANTY