However, it does not sterilize or destroy microorganisms. You may need to purchase a water purifying system to do that. In order for the
Under normal conditions, a 170 cc (5.75 oz.) cup can be fi lled in 10 seconds. If the Refrigerator
is installed in an area with low water pressure (below 138Kpa), you can install a booster pump to compensate for the low pressure.
Make sure the water storage tank inside the Refrigerator is properly fi lled. To do this, press the water dispenser lever until the water runs from the water outlet.
Water line installation kits are available at extra cost from your dealer.
We recommend using a water supply kit that contains copper tubing.
INSTALLING THE WATER LINE
Connecting the water line to the Refrigerator.
There are several items that you need to purchase to complete this connection. You may fi nd these items sold as a kit at your local hardware store.
• | 6.35mm compression | • | copper tubing |
| nut | ||
|
|
| |
|
|
|
|
• | plastic tubing | • | ferrule |
|
|
|
|
Refrigerator
The new
Check the accessory list below.
Compression fitting | Compression nut |
Plastic tubing (A) (Supplied)
Ferrule (Not supplied)
Copper tubing
(Not supplied)
Compression nut (A) (1/4”)
(Supplied)
Compression fitting (Supplied)
Molded end(Bulb)
Compression nut (B) (1/4”) (Not supplied)
or | Plastic tubing (B) | |
(Not supplied) | ||
|
Connecting to the water supply line
1.First, shut off the main water supply line and turn the
2.Locate the nearest cold water drinking line.
3.After connecting the water supply with water filter, turn on water supply and Flush 3L through filter before use (flush approximately 6 minutes).
Cold Water Line
Pipe clamp
Water line installation kit
Shut off valve
12_ setting up
Household water line
1.Slip the compression nut through the supplied plastic tubing(A).
2.Tighten the compression nut (A) onto the 6.35mm compression fitting.
-If you are using copper tubing, slip the compression nut (B)(not included) and ferrule (not included) on copper tubing (not included) as shown.
-If you are using plastic tubing (B), insert the molded end(Bulb) of the plastic tubing (B)into
the compression fitting. Do not use without the molded end(Bulb) of the plastic tubing (B).
3.Tighten the compression nut (B)onto the compression fitting. Do not
4.Turn water on and check for any leakage.
Only connect the water line to a drinkable water source. If you have to repair or disassemble the water line, cut off 6.35mm of the plastic tubing to make sure you get a snug,
2015. 5. 7. 8:10 |