Samsung SSA-R2010/EXP manual Connecting to the External Reader, External Reader Connection

Page 16

installation and external connection

CONNECTING TO THE EXTERNAL READER

External Reader Connection

Reader

DATA-0 (pink)

DATA-1 (sky blue)

DC12V (red)

GND (black)

GND (-)

OK Signal Out

Wiegand D0

CONTROLLER

Wiegand D1

Error Signal Out

DC12V

(+)

POWER

Power Supply Unit

1.Connect the DC 12V(+) line of the power supply unit to the plus (+) line of the reader.

2.Connect the GND(-) line of the power supply unit to the minus (-) line of the reader.

3.Connect the Wiegand DATA-0 line of the proximity reader to the pink line.

4.Connect the Wiegand DATA-1 line 1 of the proximity reader to the sky blue line

5.The product should be connected to GND(-) of the external reader.

•For a list of compliant readers (external readers), see the followings:

SSA-R2010/SSA-R2020/SSA-R2040

- Standard 26bit Wiegand format proximity reader

SSA-R2011 / SSA-R2021 / SSA-R2041

- Standard 34bit Wiegand format proximity reader

16_ installation and external connection

Image 16

Contents Biometric Reader Please visit our websiteSafety information Safety informationImportant Safety Instructions This device may not cause harmful interference,Contents Features Product introductionCables Quick Guide CD Manual WHAT’S IncludedMaster Card Ferrite Cores X Front Panel AT a GlanceDisplays the status of the system operation Rear Panel Pins Signal Cable Color Cable Color SchemeCable Selection Installing the Wall Mount Termination ResistorEARTH-GROUNDING the Communication Cables Host PCOverall Wiring Diagram ConnectionPower Input ConnectionController Connection of External LED controlOutput Connection Wiegand Data Output ConnectionConnecting to the External Reader External Reader ConnectionCommunication Line Connection RS-485 Communication Port Connection StandaloneRS-485 Communication Port Connection Multiple Units TCP/IP Communication Port Connection Hub Host PC RJ45 RJ45 RJ45Initializing the System Using the DIP Switch Refer to Communication Address Setup. onInitialization Master IDReader Mode Registration ModeDisplay and Operation Status of READER/REGISTER Communication Address Setup To REGISTER/DELETE the Master ID CardIf the card is not registered Reader Mode and AuthenticationPresent the registered card to the reader Registering the ID User managementTo Register the ID Card Along with the Fingerprint To Delete ID SuccessfullyWiegand Output Default Timing DiagramOutput format Data Type 26-bit /34-bitHOW to Register the Fingerprint Other informationTroubleshooting TroubleshootingProblem Action Problem Product Specifications Product speciﬁcationsCorrect disposal of batteries in this product