Samsung SSA-R2010/EXP manual Communication Line Connection

Page 17

COMMUNICATION LINE CONNECTION

RS-485 Communication Port Connection (Standalone)

A RS-485/RS-232 converter is needed to make RS-485 communications between the product and the host PC. Please follow the steps below:

INSTALLATION

RS-485/RS-232 Converter

A B

RS-232

Host PC

RS-485

Max. 1200m

Gray

Yellow

AND EXTERNAL CONNECTION

1.Connect the yellow RS-485-RTX (+) line to the RS485-A port of the converter.

2.Connect the gray RS-485-RTX (-) line to the RS485-B port of the converter.

3.Connect the RS-485/RS-232 converter to the serial port (COM port) of the host PC.

4.Install and launch the application (SAMS).

English _ 17

Image 17

Contents Please visit our website Biometric ReaderSafety information Safety informationThis device may not cause harmful interference, Important Safety InstructionsContents Product introduction FeaturesMaster Card Ferrite Cores X WHAT’S IncludedCables Quick Guide CD Manual Displays the status of the system operation AT a GlanceFront Panel Rear Panel Cable Color Scheme Pins Signal Cable ColorCable Selection Termination Resistor Installing the Wall MountHost PC EARTH-GROUNDING the Communication CablesConnection Overall Wiring DiagramInput Connection PowerController Connection of External LED controlWiegand Data Output Connection Output ConnectionExternal Reader Connection Connecting to the External ReaderRS-485 Communication Port Connection Standalone Communication Line ConnectionRS-485 Communication Port Connection Multiple Units Hub Host PC RJ45 RJ45 RJ45 TCP/IP Communication Port ConnectionRefer to Communication Address Setup. on Initializing the System Using the DIP SwitchInitialization Master IDDisplay and Operation Status of READER/REGISTER Registration ModeReader Mode To REGISTER/DELETE the Master ID Card Communication Address SetupPresent the registered card to the reader Reader Mode and AuthenticationIf the card is not registered To Register the ID Card Along with the Fingerprint User managementRegistering the ID Successfully To Delete IDTiming Diagram Wiegand Output DefaultOutput format Data Type 26-bit /34-bitOther information HOW to Register the FingerprintProblem Action TroubleshootingTroubleshooting Problem Product speciﬁcations Product SpecificationsCorrect disposal of batteries in this product