Samsung SSA-R2010/EXP manual Other information, HOW to Register the Fingerprint

Page 27

other information

HOW TO REGISTER THE FINGERPRINT

Correct Fingerprint Registration

	{
Fingerprint	Successful 1:1/1:N
scanning	Authentication

Incorrect Fingerprint Registration

	±
Fingerprint	1:1/1:N Authentication
Scanning	Error

In case of failures of ﬁngerprint recognition

•Moist Fingerprint

•Dry Fingerprint

•Stained Fingerprint

•Scarred Fingerprint

Dry	Moist	Stained
Fingerprint	Fingerprint	Fingerprint

How to manage ﬁngerprints

Follow the instructions below to increase the rate of successful authentication of the ﬁngerprint.

•For a dry ﬁngerprint, put force to present the ﬁngerprint to the scanner.

•For a moist ﬁngerprint, gently present the ﬁngerprint to the scanner.

•Keep the ﬁngerprint scanner clean all the time, especially on the surface.

OTHER INFORMATION

English _ 27

Image 27

Contents Please visit our website Biometric ReaderSafety information Safety informationThis device may not cause harmful interference, Important Safety InstructionsContents Product introduction FeaturesWHAT’S Included Cables Quick Guide CD ManualMaster Card Ferrite Cores X AT a Glance Front PanelDisplays the status of the system operation Rear Panel Cable Color Scheme Pins Signal Cable ColorCable Selection Termination Resistor Installing the Wall MountHost PC EARTH-GROUNDING the Communication CablesConnection Overall Wiring DiagramConnection of External LED control PowerInput Connection ControllerWiegand Data Output Connection Output ConnectionExternal Reader Connection Connecting to the External ReaderRS-485 Communication Port Connection Standalone Communication Line ConnectionRS-485 Communication Port Connection Multiple Units Hub Host PC RJ45 RJ45 RJ45 TCP/IP Communication Port ConnectionMaster ID Initializing the System Using the DIP SwitchRefer to Communication Address Setup. on InitializationRegistration Mode Reader ModeDisplay and Operation Status of READER/REGISTER To REGISTER/DELETE the Master ID Card Communication Address SetupReader Mode and Authentication If the card is not registeredPresent the registered card to the reader User management Registering the IDTo Register the ID Card Along with the Fingerprint Successfully To Delete IDData Type 26-bit /34-bit Wiegand Output DefaultTiming Diagram Output formatOther information HOW to Register the FingerprintTroubleshooting TroubleshootingProblem Action Problem Product speciﬁcations Product SpecificationsCorrect disposal of batteries in this product