Samsung SSA-R2010/EXP manual Contents

Page 4

contents

PRODUCT INTRODUCTION	5	Features
5	6	What’s included
	7	At a Glance
	9	Cable Color Scheme
	10	Cable Selection
INSTALLATION AND EXTERNAL	11	Installing the Wall Mount
CONNECTION	11	Termination Resistor
11	12	Earth-grounding the communication cables
	13	I/O Connection
	16	Connecting to the external reader
	17	Communication Line Connection
INITIALIZATION	20	Initializing the system using the DIP switch
20	21	Display and Operation Status of Reader/
20		Register
		Register
	22	To register/delete the master ID (card)
	22	Communication Address Setup
	23	Reader Mode and Authentication

USER MANAGEMENT

24

OUTPUT FORMAT

26

OTHER INFORMATION

27

TROUBLESHOOTING

28

PRODUCT SPECIFICATIONS

30

24Registering the ID

24To register the ID card along with the ﬁngerprint

25To delete ID

26WIEGAND Output (Default)

27How to register the ﬁngerprint

28TroubleShooting

30Product Speciﬁcations

4_ contents

Image 4

Contents Biometric Reader Please visit our websiteSafety information Safety informationImportant Safety Instructions This device may not cause harmful interference,Contents Features Product introductionCables Quick Guide CD Manual WHAT’S IncludedMaster Card Ferrite Cores X Front Panel AT a GlanceDisplays the status of the system operation Rear Panel Pins Signal Cable Color Cable Color SchemeCable Selection Installing the Wall Mount Termination ResistorEARTH-GROUNDING the Communication Cables Host PCOverall Wiring Diagram ConnectionPower Input ConnectionController Connection of External LED controlOutput Connection Wiegand Data Output ConnectionConnecting to the External Reader External Reader ConnectionCommunication Line Connection RS-485 Communication Port Connection StandaloneRS-485 Communication Port Connection Multiple Units TCP/IP Communication Port Connection Hub Host PC RJ45 RJ45 RJ45Initializing the System Using the DIP Switch Refer to Communication Address Setup. onInitialization Master IDReader Mode Registration ModeDisplay and Operation Status of READER/REGISTER Communication Address Setup To REGISTER/DELETE the Master ID CardIf the card is not registered Reader Mode and AuthenticationPresent the registered card to the reader Registering the ID User managementTo Register the ID Card Along with the Fingerprint To Delete ID SuccessfullyWiegand Output Default Timing DiagramOutput format Data Type 26-bit /34-bitHOW to Register the Fingerprint Other informationTroubleshooting TroubleshootingProblem Action Problem Product Specifications Product speciﬁcationsCorrect disposal of batteries in this product