Samsung SSA-R2010/EXP manual Cable Color Scheme, Pins Signal Cable Color

Page 9

CABLE COLOR SCHEME

❖ 2-PIN Connector

I/O Pins		Signal	Cable Color

Power (+12V)	DC +12V		Red

Earth-grounding	GND (-)		Black

❖ 6-PIN Connector

	I/O Pins			Signal	Cable Color

	EX Input Wiegand DATA0		EX-DATA0		Pink

	EX Input Wiegand DATA1		EX-DATA1		Sky Blue

	NC				Brown

	NC				Blue
	RS-485	RS-485 A(+)	RS-485	A(+)	Yellow

		RS-485 B(-)	RS-485	B(-)	Gray
		RS-485 B(-)	RS-485	B(-)	Gray

❖8-PIN Connector

I/O Pins	Signal	Cable Color

Wiegand DATA 0	DATA-0	Green

Wiegand DATA 1	DATA-1	White

ERROR SIGNAL OUT	ERROR SIGNAL OUT	Orange

OK SIGNAL OUT	OK SIGNAL OUT	Orange with Black Stripes

TAMPER OUT	TAMPER OUT	Purple

EX_LED_CONTROL	EX_LED_CONTROL	Blue with White Stripes

EX_BUZZER_CONTROL	EX_BUZZER_CONTROL	White with Red Stripes

EX_SYS_CHANGE_IN	EX_SYS_CHANGE_IN	Gray with Red Stripes

❖TCP/IP (8PIN Connector) RJ45 cable connected

PRODUCT INTRODUCTION

English _ 9

Image 9

Contents Please visit our website Biometric ReaderSafety information Safety informationThis device may not cause harmful interference, Important Safety InstructionsContents Product introduction FeaturesWHAT’S Included Cables Quick Guide CD ManualMaster Card Ferrite Cores X AT a Glance Front PanelDisplays the status of the system operation Rear Panel Cable Color Scheme Pins Signal Cable ColorCable Selection Termination Resistor Installing the Wall MountHost PC EARTH-GROUNDING the Communication CablesConnection Overall Wiring DiagramInput Connection PowerController Connection of External LED controlWiegand Data Output Connection Output ConnectionExternal Reader Connection Connecting to the External ReaderRS-485 Communication Port Connection Standalone Communication Line ConnectionRS-485 Communication Port Connection Multiple Units Hub Host PC RJ45 RJ45 RJ45 TCP/IP Communication Port ConnectionRefer to Communication Address Setup. on Initializing the System Using the DIP SwitchInitialization Master IDRegistration Mode Reader ModeDisplay and Operation Status of READER/REGISTER To REGISTER/DELETE the Master ID Card Communication Address SetupReader Mode and Authentication If the card is not registeredPresent the registered card to the reader User management Registering the IDTo Register the ID Card Along with the Fingerprint Successfully To Delete IDTiming Diagram Wiegand Output DefaultOutput format Data Type 26-bit /34-bitOther information HOW to Register the FingerprintTroubleshooting TroubleshootingProblem Action Problem Product speciﬁcations Product SpecificationsCorrect disposal of batteries in this product