Samsung SSA-R2010/EXP manual To Delete ID, Successfully

Page 25

TO DELETE ID

1.Check if the green and orange indicators are all turned off when the reader turns on.

	2. Present the master card to the reader. You will hear the following		REGISTRATION AND
	voice message with the green and orange indicators blinking.	Q	REGISTRATION AND
		Q	DELETION MODE, SCAN
			YOUR CARD

3.Present a registered user card to the reader. When you hear the following message with a beep four times, the user is deleted

successfully.

Q ID DELETED

•When the ID is deleted, the ﬁngerprint data will be deleted too.

4.Repeat step 3 above if you want to delete another user.

5.When the ID deletion is completed, present the master card to exit the registration mode.

USER MANAGEMENT

English _ 25

Image 25

Contents Please visit our website Biometric ReaderSafety information Safety informationThis device may not cause harmful interference, Important Safety InstructionsContents Product introduction FeaturesCables Quick Guide CD Manual WHAT’S IncludedMaster Card Ferrite Cores X Front Panel AT a GlanceDisplays the status of the system operation Rear Panel Cable Color Scheme Pins Signal Cable ColorCable Selection Termination Resistor Installing the Wall MountHost PC EARTH-GROUNDING the Communication CablesConnection Overall Wiring DiagramInput Connection PowerController Connection of External LED controlWiegand Data Output Connection Output ConnectionExternal Reader Connection Connecting to the External ReaderRS-485 Communication Port Connection Standalone Communication Line ConnectionRS-485 Communication Port Connection Multiple Units Hub Host PC RJ45 RJ45 RJ45 TCP/IP Communication Port ConnectionRefer to Communication Address Setup. on Initializing the System Using the DIP SwitchInitialization Master IDReader Mode Registration ModeDisplay and Operation Status of READER/REGISTER To REGISTER/DELETE the Master ID Card Communication Address SetupIf the card is not registered Reader Mode and AuthenticationPresent the registered card to the reader Registering the ID User managementTo Register the ID Card Along with the Fingerprint Successfully To Delete IDTiming Diagram Wiegand Output DefaultOutput format Data Type 26-bit /34-bitOther information HOW to Register the FingerprintTroubleshooting TroubleshootingProblem Action Problem Product speciﬁcations Product SpecificationsCorrect disposal of batteries in this product