Monessen Hearth HDV500NV/PV manual Optional FAN Blower System, AC Box

HDV Series Direct Vent Gas Fireplace OPTIONAL FAN BLOWER SYSTEM

Optional Fan/BlOwer System

(BLOTBLDVSC) Installation Instructions Wiring

1.Before installing the blower, wire the receptacle into an electri- cal circuit. This should be done before framing the fireplace. Wire with minimum 60° C wire in accordance with prevailing codes.

2.Remove the external junction box cover by removing the screw from the left side of the outside firebox wall. Junction box was installed at the factory.

120V AC

60Hz

Factory Supplied

Not Supplied

Junction Box

Figure 52 -

Junction Box Wiring Diagram

3.The junction box cover has a factory installed “romex” style

strain relief connector. After connecting the wires, route the wire leads through this con- nector. Refer to the wiring diagram in Figure 52.

	To Junction Box
	In Fireplace
Dual			Optional
			AC Box
Blowers	Optional	{
(300 W	Light		WHITE
Max)	WHITE		BLACK
	BLACK		BLACK
	Optional	{ WHITE
Dual	AUX
			GREEN
Blowers			Connector
(300 W
			Pin To Control Box
Max)	Figure 53 -
	Blower Wiring Diagram
			Control Box
			FP2103

WARNING

Electrical Grounding Instructions: This appliance is equipped with a three-prong (grounding) plug for your protection against shock hazard and should be plugged directly into a properly grounded three- prong receptacle.

WARNING

Electrical connections should only be performed by a qualified licensed electrician. Main power supply must be turned off before connecting the fan to the main electrical power supply or performing service.

36 56D3048