Napoleon Fireplaces GD19P, GD19N manual TABLE of CONTENTS, Retain This Manual For Future Reference

Page 2
TABLE of CONTENTS

2

TABLE of CONTENTS

PG 2-5 INTRODUCTION

25

BLOWER INSTALLATION

 

Warranty

25

NIGHT LIGHTTM REPLACEMENT

 

General Instructions

 

 

 

General Information

26-27

FINISHING

 

Care of Glass and Plated Parts

 

Glass Door Installation and Removal

 

Dimensions

 

Log Placement

5-15

VENTING

 

Logo Placement

 

Control Functions

 

Venting Lengths and Air Terminal Locations

 

 

 

 

 

Typical Vent Installations

28

WIRING DIAGRAM

 

Special Vent Installations

 

29

OPERATION / MAINTENANCE

 

Minimum Air Terminal Location Clearances

 

Venting Application Flow Chart

 

Operating Instructions

 

Venting Specifications

 

Maintenance

 

Top Exit Conversion

30

ADJUSTMENTS

16-23

INSTALLATION

 

Pilot Injector and Orifice Replacement

 

Wall and Ceiling Protection

 

Venturi Adjustment

 

Horizontal Installation

 

Flame Adjustment

 

Vertical Installation

 

Flame Characteristics

 

Using Flexible Vent Components

 

 

 

 

 

Fireplace Vent Connection

31-32

REPLACEMENTS

 

Using Rigid Vent Components

 

Ordering Replacement Parts

 

Restricting Vertical Vents

 

 

 

Replacement Parts

 

Mobile Home Installation

 

 

 

Terminal Kits

 

Gas Installation

 

 

 

Accessories

 

Optional Wall Switch Installation

 

 

 

 

 

Framing

33-34

TROUBLE SHOOTING GUIDE

 

Minimum Mantel and Enclosure Clearances

35

SERVICE HISTORY

24

FRONT FACING AND INSERT KIT

36

NOTES

RETAIN THIS MANUAL FOR FUTURE REFERENCE

!WARNING

Do not burn wood or other materials in this fireplace.

Adults and especially children should be alerted to the hazards of high surface temperatures and should stay away to avoid burns or clothing ignition. Supervise young children when they are in the same room as the fireplace.

Clothing or other flammable material should not be placed on or near the fireplace.

Due to high temperatures, the fireplace should be located out of traffic and away from furniture and draperies.

Ensure you have incorporated adequate safety measure to protect infants/toddlers from touching hot surfaces.

Even after the fireplace is out, the glass and/or screen will remain hot for an extended period of time.

Check with your local hearth specialty dealer for safety screens and hearth guards to protect children from hot surfaces. These screens and guards must be fastened to the floor.

Any safety screen or guard removed for servicing must be replaced prior to operating the fireplace.

It is imperative that the control compartments, burners and circulating blower and its passageway in the fireplace and venting system are kept clean. The fireplace and its venting system should be inspected before use and at least annually by a qualified service person. More frequent cleaning may be required due to excessive lint from carpeting, bedding material, etc. The fireplace area must be kept clear and free from combustible materials, gasoline and other flammable vapours and liquids.

Under no circumstances should this fireplace be modified.

This fireplace must not be connected to a chimney flue pipe serving a separate solid fuel burning appliance.

Do not use this fireplace if any part has been under water. Immediately call a qualified service technician to inspect the fireplace and to replace any part of the control system and any gas control which has been under water.

Do not operate the fireplace with the glass door removed, cracked or broken. Replacement of the glass should be done by a licensed or qualified service person.

Do not strike or slam shut the fireplace glass door.

This fireplace uses and requires a fast acting thermocouple. Replace only with a fast acting thermocouple supplied by Wolf Steel Ltd.

Pressure relief doors must be kept closed while the fireplace is operating to prevent exhaust fumes containing carbon

monoxide, from entering into the home. Temperatures of the exhaust escaping through these openings can also cause the surrounding combustible materials to overheat and catch fire.

• Only doors/optional fronts certified with the appliance shall be used.

NOTE: Changes, other than editorial, are denoted by a vertical line in the margin.

W415-0612 / C / 01.25.08

Image 2
Contents GD19N INSTALLATION AND OPERATION INSTRUCTIONSSAFETY INFORMATION GD19PTABLE of CONTENTS RETAIN THIS MANUAL FOR FUTURE REFERENCECONDITIONS AND LIMITATIONS CARE OF GLASS AND PLATED PARTS GENERAL INSTRUCTIONSGENERAL INFORMATION VENTING VERTICAL VENT SECTIONS VENT INSTALLATIONSHORIZONTAL VENT SECTIONS FOR SPECIFIC VENTING PARAMETERS, REFER TO PAGESREAR EXIT TYPICAL VENT INSTALLATIONSSPECIAL VENT INSTALLATIONS TOP EXITMINIMUM AIR TERMINAL LOCATION CLEARANCES W415-0612 /CREAR EXIT VENTING APPLICATION FLOW CHARTFIREPLACE VENT EXIT TOP EXITELBOW VENT LENGTH VALUES TOP EXIT / HORIZONTAL TERMINATIONDEFINITIONS HT VTTOP EXIT / HORIZONTAL TERMINATION HT VT REAR EXIT / HORIZONTAL TERMINATIONH2 REAR EXIT / HORIZONTAL TERMINATION TOP OR REAR EXIT VERTICAL TERMINATION HT VTHT VT TOP EXIT CONVERSION VERTICAL INSTALLATION INSTALLATION WALL AND CEILING PROTECTIONHORIZONTAL INSTALLATION 3/4”VERTICAL AIR TERMINAL INSTALLATION USING FLEXIBLE VENT COMPONENTSHORIZONTAL AIR TERMINAL INSTALLATION FIREPLACE VENT CONNECTION RESTRICTING VERTICAL VENTS VERTICAL VENTING INSTALLATIONAIR TERMINAL INSTALLATION EXTENDED HORIZONTAL AND CORNERELECTRICAL INSTALLATION MOBILE HOME INSTALLATIONGAS INSTALLATION OPTIONAL WALL SWITCH INSTALLATIONTOP VENT FRAMINGREAR VENT Combustible Framing 0 to stand-offsMINIMUM MANTEL AND ENCLOSURE CLEARANCES FIGURES 41a&bFRONT FACING AND INSET KIT INSTALLATION FIREBOXBULB REPLACEMENT BLOWER INSTALLATIONNIGHT LIGHT REPLACEMENT LENS ASSEMBLY INSTALLATIONDOOR GLASS REPLACEMENT FINISHINGGLASS DOOR INSTALLATION AND REMOVAL LOG PLACEMENTFLAME ADJUSTMENT LOGO PLACEMENTMAIN BURNER SWITCH NIGHT LIGHTTM SWITCHWIRING DIAGRAM See detail for optional wall switch GD-660wiringFOR YOUR SAFETY READ BEFORE OPERATING OPERATION / MAINTENANCEMAINTENANCE OPERATING INSTRUCTIONSVENTURI ADJUSTMENT ADJUSTMENTSPILOT INJECTOR AND ORIFICE REPLACEMENT FLAME ADJUSTMENTACCESSORIES REPLACEMENTSREPLACEMENT PARTS FOR WARRANTY REPLACEMENT PARTS, A PHOTOCOPY OFW415-0612 /C PROBLEM TROUBLE SHOOTING GUIDESYMPTOM TEST SOLUTIONTEST SOLUTION SYMPTOMPROBLEM Pilot lightsThis fireplace must be Fireplace Service Historyserviced annually depending on usage W415-0612 /CW415-0612 /C