26
FINISHING
GLASS DOOR INSTALLATION AND REMOVAL
Before the glass door can be removed, the optional front must be removed. The glass door is secured to the top front edge of the firebox and retained by the bottom.
1.Unlatch door
2.Pull handle and rotate 90°.
3.Pivot door slightly and lift out of bottom retainer.
90° 
FIGURE 58
DOOR GLASS REPLACEMENT
1. Place the door frame face down careful not to scratch the paint.
2. Center the gasketed glass inside the door | GASKET |
frame with the thick side of the gasket facing |
|
up. |
|
3. Bend the glass retainers located along the edge of the door frame over the gasket holding the glass in place. Careful not to break the glass.
NOTE: Care must be taken when removing and disposing of any broken glass or damaged components. Be sure to vacuum up any broken glass from inside the fireplace before operation.
GLASS
DOOR
FRAME
FIGURE 59
GLASS RETAINERS
LOG PLACEMENT
In order to assemble the log set, the glass door must be removed, see Glass Door Installation and Removal.
FIGURE 60a-d
BRACKET1.Place the rear log as shown, ensuring the holes on the underside are placed onto the 2 pins of the log support.
2.Place the left log as shown, ensuring the hole on the underside is placed onto the burner pin. This will rest on the left side of the rear log.