29
OPERATION / MAINTENANCE
Purge all gas lines with the glass door of the fireplace removed or opened. Assure that a continuous gas flow is at the burner before installing the door.
When lit for the first time, the fireplace will emit a slight odour by the
After extended periods of
FOR YOUR SAFETY READ BEFORE OPERATING
!WARNING
IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING
PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.
A. THIS FIREPLACE IS EQUIPPED WITH AN IGNITION DEVICE WHICH AUTOMATICALLY LIGHTS THE PILOT. DO NOT TRY TO LIGHT BY HAND.
B. BEFORE OPERATING SMELL ALL AROUND THE FIREPLACE AREA FOR GAS AND NEXT TO THE FLOOR BECAUSE SOME GAS IS HEAVIER THAN AIR AND WILL SETTLE ON THE FLOOR.
C. USE ONLY YOUR HAND TO TURN THE GAS CONTROL KNOB. NEVER USE TOOLS. IF THE KNOB WILL NOT TURN BY HAND, DO NOT TRY TO REPAIR IT. CALL A QUALIFIED SERVICE TECHNICIAN. FORCE OR ATTEMPTED REPAIR MAY RESULT IN A FIRE OR EXPLOSION.
D. DO NOT USE THIS FIREPLACE IF ANY PART HAS BEEN UNDER WATER. IMMEDIATELY CALL A QUALIFIED SERVICE TECHNICIAN TO INSPECT THE FIREPLACE AND REPLACE ANY PART OF THE CONTROL SYSTEM AND ANY GAS CONTROL WHICH HAS BEEN UNDER WATER.
WHAT TO DO IF YOU SMELL GAS:
•TURN OFF ALL GAS TO THE FIREPLACE.
•OPEN WINDOWS.
•DO NOT TRY TO LIGHT ANY APPLIANCE.
•DO NOT TOUCH ANY ELECTRIC SWITCH; DO NOT USE ANY PHONE IN YOUR BUILDING.
•IMMEDIATELY CALL YOUR GAS SUPPLIER FROM A NEIGHBOUR'S PHONE FOLLOW THE GAS SUPPLIER'S INSTRUCTIONS.
•IF YOU CANNOT REACH YOUR GAS SUPPLIER, CALL THE FIRE DEPARTMENT.
OPERATING INSTRUCTIONS
1.STOP! READ THE ABOVE SAFETY INFORMATION ON THIS LABEL.
2.TURN REMOTE WALL SWITCH TO OFF POSITION.
3.TURN OFF ALL ELECTRIC POWER TO THE FIREPLACE AND REMOVE BATTERIES.
4.THIS FIREPLACE IS EQUIPPED WITH AN IGNITION DEVICE WHICH AUTOMATICALLY LIGHTS THE PILOT. DO NOT TRY TO LIGHT THE PILOT BY HAND.
5.TURN MANUAL SHUTOFF VALVE CLOCKWISE 
TO OFF.
6.OPEN THE GLASS DOOR.
7.WAIT FIVE (5) MINUTES TO CLEAR OUT ANY GAS. IF YOU SMELL GAS INCLUDING NEAR THE FLOOR, STOP! FOLLOW "B" IN THE ABOVE SAFETY INFORMATION ON THIS LABEL. IF YOU DON'T SMELL GAS GO TO THE NEXT STEP.
8.CLOSE THE GLASS DOOR.
9.TURN MANUAL SHUTOFF VALVE COUNTER-
CLOCKWISE 
TO ON.
10.TURN ON ALL ELECTRIC POWER TO THE FIREPLACE AND
11.TURN ON REMOTE WALL SWITCH TO ON POSITION.
12.IF FIREPLACE WILL NOT OPERATE, FOLLOW INSTRUCTIONS "TO TURN OFF GAS" AND CALL YOUR SERVICE TECHNICIAN OR GAS SUPPLIER.
Manual
Shown in “OFF”
position.
TO TURN OFF GAS
1.TURN OFF REMOTE WALL SWITCH TO THE FIREPLACE.
2.TURN OFF ALL ELECTRICAL POWER TO THE FIREPLACE IF SERVICE IS TO BE PERFORMED.
3.TURN MANUAL SHUTOFF VALVE CLOCKWISE 
TO OFF. DO NOT FORCE.
MAINTENANCE
TURN OFF THE GAS AND UNPLUG ELECTRICAL POWER BEFORE SERVICING THE STOVE:
Caution: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing. This stove and its venting system should be inspected before use and at least annually by a qualified service person. The fireplace area must be kept clear and free of combustible materials, gasoline or other flammable vapours and liquids. The flow of combustion and ventilation air must not be obstructed.
1.In order to properly clean the burner and pilot assembly, remove the logs exposing both assemblies.
2.Keep the control compartment, logs, burner, air shutter opening and the area surrounding the logs clean by vacuuming or brushing, at least once a year.
3.Check to see that all burner ports are burning. Clean out any of the ports which may not be burning or are not burning properly.
4.Check to see that the pilot flames are large enough to engulf the sensor on one leg and reaches toward the burner on the other leg.
5.Replace the cleaned logs.
6.Check to see that the main burner ignites completely on all openings when the gas knob for the burner is turned on.
A
longer, consult your Napoleon® dealer/distributor.
7.Check that the door gasketing is not broken or missing.
8.If for any reason the vent air intake system is disassembled,