Vanguard Heating VP2000BTC, VP2800BTC Installing To Wall, Check GAS Type, Installation Items

INSTALLING	NOTICE
TO WALL
	A qualified service person must install heater. Follow all local codes.
	CHECK GAS TYPE
	Use only propane/LP gas. If your gas supply is not propane/LP, do not install
	heater. Call dealer where you bought heater for proper type heater.
	INSTALLATION ITEMS
	Before installing heater, make sure you have the items listed below.
	• external regulator (supplied by	• manual shutoff valve *	•	sediment trap
	installer, see page 14)	• ground joint union	•	tee joint
	• piping (check local codes)	• test gauge connection *	• pipe wrench
	• sealant (resistant to propane/LP gas)	(see Figure 14, page 15)

*An A.G.A. design-certified manual shutoff valve with 1/8" NPT tap is an acceptable alternative to test gauge connection. The optional A.G.A. design-certified manual shutoff valve can be purchased from your dealer. See Accessories, page 30.

LOCATING HEATER

This heater is designed to be mounted on a wall.

WARNING

WARNING ICON G 001

Maintain the minimum clearances shown in Figure 4 (page 10). If you can, provide greater clearances from floor, ceiling, and joining wall.

You can locate heater on floor, away from a wall. An optional floor mounting stand is needed. Purchase the floor mounting stand from your dealer. See Accesso- ries, page 30.

WARNING

WARNING ICON G 001

Never install the heater

•in a bedroom or bathroom

•in a recreational vehicle

•where curtains, furniture, clothing, or other flammable objects are less than 36 inches from the front, top, or sides of the heater

•as a fireplace insert

•in high traffic areas

•in windy or drafty areas

CAUTION

WARNING ICON G 001

This heater creates warm air currents. These currents move heat to wall surfaces next to heater. Installing heater next to vinyl or cloth wall coverings or operating heater where impurities in the air (such as tobacco smoke) exist, may discolor walls.

IMPORTANT: Vent-free heaters add moisture to the air. Although this is beneficial, in- stalling heater in rooms without enough ventilation air may cause mildew to form from too much moisture. See Air for Combustion and Ventilation, pages 5 through 8.

CAUTION

WARNING ICON G 001

If you install the heater in a home garage

•heater pilot and burner must be at least 18 inches above floor

•locate heater where moving vehicle will not hit it

Continued 9

103876