Jotul GF 400 DV manual Annual Cleaning, Glass Care, Vent System, Burner and Logset

Page 24

Maintenance

Your Jøtul GF 400 DV Sebago and its venting system should be inspected before use and at least annually by a qualified service technician.

Use the form on page 30 to keep a maintenance history of your stove.

IMPORTANT:

ALWAYS TURN OFF THE GAS SUPPLY TO THE FIREPLACE AND UNPLUG THE FORCED AIR BLOWER BEFORE ANY SERVICE WORK IS PERFORMED ON THE FIREPLACE.

Annual Cleaning

Vent System

The entire vent system, including the chimney, should be inspected and cleaned every year. If the intake and exhaust venting is disassembled for any reason, it should be reassembled and sealed according to the manufacturer’s instructions provided at the initial installation.

Burner and Logset

Periodically inspect the Firebox, Valve Compartment, Convection Airways and optional Blower to BE CERTAIN THAT THE FLOW OF COMBUSTION AND VENTILATION AIR IS UNOBSTRUCTED.

The firebox should be vacuumed annually to remove any surface build up. Use a soft brush attachment and handle the logs carefully as they are fragile. Be sure to vacuum or wipe off the pilot assembly and burner surfaces.

Glass Care

Clean the glass only when necessary. Wipe the surface with a clean, dampened, soft cloth. Follow with a dry, soft towel. Take care not to scratch the glass surface.

WARNING:

DO NOT USE ABRASIVE CLEANERS ON THE GLASS. NEVER CLEAN THE GLASS WHEN IT IS HOT.

Gasket Inspection

It is important that the glass gasket be inspected at least annually. Examine the ribbon gasket for signs of deterioration and make sure the gasket has a positive seal. Replace the gasket if necessary. Refer to the replacement parts list on page 29.

FOR REPLACEMENT, USE ONLY JØTUL CERAMIC GLASS PANEL 220089. DO NOT USE ANY OTHER TYPE OF GLASS WITH THIS APPLIANCE.

Glass Panel or Gasket Removal

1.Lift the Top Plate off of the stove.

2.Release the two Glass Frame Latches. Pull each latch handle forward forward to disengage the latch from the notches in the glass frame.

3.Lift the glass frame all the way up and out of the top of the stove. Lay this assembly on a flat surface, protecting the frame from scratches using a blanket or towel.

3.The glass panel is held in place by four compression clips. Use a screwdriver or small pliers to pry these up off the edge of the glass retaining walls. See fig. 40.

4.Remove the old gasket material. See fig. 41.

Glass Clips

Figure 40. Use small pliers to pry the clips off of the glass panel frame.

Glass Panel or Gasket Replacement

1.Wrap the new gasketing material evenly around the edge of the glass, peeling back the protective strip to expose the adhesive as you go. Press the adhesive side down onto the glass surface. Do not stretch the gasket.

2.Place the gasketed glass within the frame and press each of the retainer clips back into place on the retainer walls.

Figure 41. Wrap the gasket around the glass panel.

24

Page 23 Page 25
Image 24
Page 23 Page 25
Contents Jøtul GF 400 DV Sebago Gas Heater Welcome to Jøtul Table of Contents Jøtul GF 400 DV Sebago Direct Vent Gas HeaterGF 400 DV Sebago Specifications Suggested Tools for Installation and ServiceInput Rates Hardware Bag Contents Unpacking your stoveGlass Panel Safety Information LocationHearth Requirements Alcove Installation Minimum Clearances from the Vent Pipe to CombustiblesHorizontal Run Vertical RunVenting Requirements Vent RestrictionIntake Air Restrictor Exhaust RestrictorVertical Vent Termination Front LEG Back„ Minimum Vertical run must be at least 8 ft .43 m Vent Termination Zones Natural Gas Vertical Termination forVent Termination Zones Propane Venting Must Terminate END Within the Shaded AreaCo-linear Vent Installation These installation requirements must be followedMasonry or Prefabricated Chimney Conversion Horizontal Termination Snorkel Terminations„ With a 14 Snorkel „ With a 36 SnorkelHorizontal Termination Clearance Min inches, U.S. / *12 inches 30 cm canMobile Home Installation Conversion Kit ContentsTools required Regulator tower labeled for propane Regulator tower screwsFuel Conversion Procedure #33 for NG Mm for LPGBurner Plate Brass Elbow Burner OrificeAdjust the Air Shutter Gas Supply ConnectionNever USE AN Open Flame to Check for GAS Leaks High Altitude Adjustment Gas PressureLeak test Always Test Pressures with Valve Control Knob SET on HighFlame Appearance / Air Shutter Adjustment Optional Wall Thermostat or Remote ControlRemote Control FrontLog Set Installation Install Right LogSystem Check Proper pilot flame appearanceOperation Lighting of the appliance. This fog will disappear asAnnual Cleaning Glass CareVent System Burner and LogsetConnect power cord to outlet Short phillips screwdriverWingscrew Snapstat Connectors Male Quickconnector Blower OperationInstall the Rear Panel Blocking the Pilot Assembly OpeningReplace the Glass Frame Replace the Top PlateGF 400 DV Sebago Illustrated Parts Breakdown GF 400 DV Sebago Parts List Name of Installer Serial NumberDate of Purchase Purchased fromWhat to do if YOU Smell GAS Control ValvePush in gas control knob slightly and turn clockwise toOFF November 2005 137750-E Jøtul ASBox Fredrikstad Norway Jøtul North America

GF 400 DV specifications

The Jotul GF 400 DV is a highly sought-after gas stove, known for its excellent efficiency and stylish design. This innovative heating solution combines traditional aesthetics with modern technology to create a product that is not only functional but also enhances any living space.

One of the standout features of the Jotul GF 400 DV is its elegant cast iron construction. The durability of cast iron ensures that the stove retains heat longer, providing warmth even after the fire goes out. The design incorporates a large viewing window that allows for an unparalleled view of the flames, fostering a cozy atmosphere. The stove is available in several finishes, including classic black, which complements a variety of home decors.

Efficiency is a key characteristic of the GF 400 DV, as it is designed to achieve a high thermal efficiency rating. It utilizes direct venting technology, allowing for easy installation and efficient combustion. This technology facilitates the venting of exhaust gases outside the home, ensuring indoor air quality remains pristine. The adjustable heat output allows users to customize the warmth according to their needs.

Another impressive feature of the Jotul GF 400 DV is the inclusion of a variable flame adjustment system. This system enables users to control the intensity of the flames, providing both ambiance and practicality. The stove can produce up to 25,000 BTUs, making it suitable for heating medium to large spaces, with an estimated heating area of around 800 to 1,500 square feet.

The GF 400 DV is equipped with electronic ignition for hassle-free startup. Additionally, it features a remote control option, allowing users to operate the stove conveniently from a distance. The manual control option is also available for those who prefer a more traditional experience.

In terms of safety, the stove comes with built-in safety measures, including a flame failure device that automatically shuts off the gas supply if the flame goes out unexpectedly.

Overall, the Jotul GF 400 DV gas stove represents the perfect blend of traditional craftsmanship and modern efficiency. Its combination of aesthetics, innovative features, and practical heating capabilities makes it an ideal choice for homeowners looking to add warmth and character to their living spaces. Whether you’re enjoying a quiet evening at home or entertaining guests, this stove is sure to impress with its performance and beauty.
Top Page Image Contents