Jotul GF 400 DV manual What to do if YOU Smell GAS, Control Valve

Page 31
Pilot Assembly

LIGHTING INSTRUCTIONS

FOR YOUR SAFETY, READ BEFORE LIGHTING.

WARNING:

IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY

RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY, OR LOSS OF LIFE.

A. This appliance has a pilot which must be lit by hand. When lighting the pilot, follow these instructions exactly.

B.BEFORE LIGHTING, smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle to the floor.

WHAT TO DO IF YOU SMELL GAS:

Extinguish any open flame.

Open windows.

Do not light any appliance.

Do not touch any electrical switches.

Do not use any phone in your building.

Immediately call your gas supplier from a neighbor’s phone.

If your gas supplier cannot be reached, call the fire department.

C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, do not try to repair it. Call a qualified technician. Force or attempted repair may result in a fire or explosion.

D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

LIGHTING INSTRUCTIONS

1.STOP! Read the safety information above.

2.Access the lower controls.

3.Turn the stove ON/OFF switch to“OFF”,or set the thermostat to lowest setting (if used).

4.Confirm that the gas supply line shut-off valve is open.

Control

 

 

Knob

PILOT

ON

 

OFF

 

 

Control Valve

5.Push in gas control knob slightly and turn clockwise to“OFF”.

NOTE: Knob cannot be turned from“PILOT” to“OFF” unless the knob is pushed in slightly. Do not force.

6.Wait five (5) minutes to clear out any gas. If you then smell gas, STOP! Follow“B”in the safety information above on this page. If you do not smell gas,go to the

next step.

7.Push in gas control knob slightly and turn counter-

clockwise to“PILOT”.

8.Push in control knob all the way and hold in. Immediately light the pilot by triggering the spark ignitor (push the red button repeatedly) until pilot lights. Continue to hold the control knob in for

about one minute after the pilot lights. Release knob and it should spring back. The pilot should remain lit. If it goes out, repeat Steps 5 through 8.

• If knob does not

return when released, stop and immediately call your service technician or gas supplier.

If pilot will not stay lit after several tries, turn the control knob to OFF and call your service technician or gas supplier.

9. Turn gas control knob counterclockwise

to“ON”.

10.Turn the stove ON/OFF switch to“ON”,or set thermostat (if used) to desired temperature.

TO TURN OFF GAS TO THE APPLIANCE:

1.Turn ON/OFF switch to”OFF”.The pilot will remain lit for normal service.

2.For complete shutdown, turn ON/OFF switch to“OFF”.

3.Access the lower controls.

4.Depress gas control knob slightly and turn clock-

wise

to“OFF”. Do not force.

31

Image 31
Contents Jøtul GF 400 DV Sebago Gas Heater Welcome to Jøtul Jøtul GF 400 DV Sebago Direct Vent Gas Heater Table of ContentsSuggested Tools for Installation and Service GF 400 DV Sebago SpecificationsInput Rates Unpacking your stove Hardware Bag ContentsGlass Panel Location Safety InformationHearth Requirements Vertical Run Alcove InstallationMinimum Clearances from the Vent Pipe to Combustibles Horizontal RunExhaust Restrictor Venting RequirementsVent Restriction Intake Air RestrictorFront LEG Back Vertical Vent Termination„ Minimum Vertical run must be at least 8 ft .43 m Vertical Termination for Vent Termination Zones Natural GasVenting Must Terminate END Within the Shaded Area Vent Termination Zones PropaneThese installation requirements must be followed Co-linear Vent InstallationMasonry or Prefabricated Chimney Conversion „ With a 36 Snorkel Horizontal TerminationSnorkel Terminations „ With a 14 SnorkelMin inches, U.S. / *12 inches 30 cm can Horizontal Termination ClearanceRegulator tower labeled for propane Regulator tower screws Mobile Home InstallationConversion Kit Contents Tools requiredBrass Elbow Burner Orifice Fuel Conversion Procedure#33 for NG Mm for LPG Burner PlateGas Supply Connection Adjust the Air ShutterNever USE AN Open Flame to Check for GAS Leaks Always Test Pressures with Valve Control Knob SET on High High Altitude AdjustmentGas Pressure Leak testFront Flame Appearance / Air Shutter AdjustmentOptional Wall Thermostat or Remote Control Remote ControlInstall Right Log Log Set InstallationProper pilot flame appearance System CheckLighting of the appliance. This fog will disappear as OperationBurner and Logset Annual CleaningGlass Care Vent SystemShort phillips screwdriver Connect power cord to outletBlower Operation Wingscrew Snapstat Connectors Male QuickconnectorReplace the Top Plate Install the Rear PanelBlocking the Pilot Assembly Opening Replace the Glass FrameGF 400 DV Sebago Illustrated Parts Breakdown GF 400 DV Sebago Parts List Purchased from Name of InstallerSerial Number Date of PurchaseControl Valve What to do if YOU Smell GASPush in gas control knob slightly and turn clockwise toOFF Jøtul North America November 2005 137750-EJøtul AS Box Fredrikstad Norway

GF 400 DV specifications

The Jotul GF 400 DV is a highly sought-after gas stove, known for its excellent efficiency and stylish design. This innovative heating solution combines traditional aesthetics with modern technology to create a product that is not only functional but also enhances any living space.

One of the standout features of the Jotul GF 400 DV is its elegant cast iron construction. The durability of cast iron ensures that the stove retains heat longer, providing warmth even after the fire goes out. The design incorporates a large viewing window that allows for an unparalleled view of the flames, fostering a cozy atmosphere. The stove is available in several finishes, including classic black, which complements a variety of home decors.

Efficiency is a key characteristic of the GF 400 DV, as it is designed to achieve a high thermal efficiency rating. It utilizes direct venting technology, allowing for easy installation and efficient combustion. This technology facilitates the venting of exhaust gases outside the home, ensuring indoor air quality remains pristine. The adjustable heat output allows users to customize the warmth according to their needs.

Another impressive feature of the Jotul GF 400 DV is the inclusion of a variable flame adjustment system. This system enables users to control the intensity of the flames, providing both ambiance and practicality. The stove can produce up to 25,000 BTUs, making it suitable for heating medium to large spaces, with an estimated heating area of around 800 to 1,500 square feet.

The GF 400 DV is equipped with electronic ignition for hassle-free startup. Additionally, it features a remote control option, allowing users to operate the stove conveniently from a distance. The manual control option is also available for those who prefer a more traditional experience.

In terms of safety, the stove comes with built-in safety measures, including a flame failure device that automatically shuts off the gas supply if the flame goes out unexpectedly.

Overall, the Jotul GF 400 DV gas stove represents the perfect blend of traditional craftsmanship and modern efficiency. Its combination of aesthetics, innovative features, and practical heating capabilities makes it an ideal choice for homeowners looking to add warmth and character to their living spaces. Whether you’re enjoying a quiet evening at home or entertaining guests, this stove is sure to impress with its performance and beauty.