Petsafe PPA11-10709 Operate, Programming a New SmartKey, Attach the SmartKey to the Pet’s Collar

Page 11

C. Programming a New SmartKey

To reduce error while programming, remove the RFA-67 battery from all programmed SmartKeysexcept the one you are programming. Press and hold the LEARN button until the green light illuminates and begins to flash, now release the button. Bring the SmartKeydirectly below the green light and the light will stop flashing and illuminate for two seconds. Now your new SmartKeyhas been programmed and added to memory. Up to five different SmartKeyscan be added, one at a time.

D. Attach the SmartKeyto the Pet’s Collar

A split key ring has been provided to attach to your pet’s collar and should hang under the pet’s neck.

The SmartDoorincludes (one) SmartKeywhich comes pre-programmed and ready to use.

OPERATE

Operating Your SmartDoor

LOCKED MODE – Does not allow entry or exit for any pet. The SmartDoorships from the factory in LOCKED MODE and when batteries are placed in the SmartDoor, it will enter LOCKED MODE. To set: hold the MODE-RESET button until the red light illuminates and release when selected.

UNLOCKED MODE – Allows entry and exit for all pets. To set: hold the MODE-RESET button until the green light illuminates and release when selected.

AUTOMATIC MODE – Allows entry and exit for a pet wearing a programmed SmartKey; up to five SmartKeyscan be programmed into one SmartDoorfor selective entry and exit during automatic mode. To set: hold the MODE-RESET button until the yellow light illuminates and release when selected.

NOTE: If at any time the red light remains illuminated, replace with a set of fresh batteries. If that does not reset the red light, please call our Customer Care Center for additional help.

Illuminating Color

Condition

Pet Door Status

 

 

 

 

Solid only for two seconds after

LOCKED Mode

RED

selecting LOCKED Mode

 

Flashing

Low battery alert

 

 

Constant solid

Internal failure has occurred

 

 

 

 

Solid only for two seconds after

UNLOCKED Mode

GREEN

selecting UNLOCKED Mode

 

 

Flashing

Learn Mode

 

Solid only for two seconds after

AUTOMATIC Mode

YELLOW

selecting AUTOMATIC Mode

 

 

Flashing

Error alert

 

 

 

RED, GREEN AND YELLOW

Flashing at the same time

Sensitivity Test Mode

 

 

 

Troubleshooting

SmartDoordoes not respond to the presence of the SmartKeywhen my pet is directly in front of the SmartDoorwithin three seconds

Check that the SmartDooris in AUTOMATIC Mode.

Check that the SmartKeyhas been programmed to the SmartDoor.

Check sensitivity level has been properly set, see page 10.

Check that the RFA-67 battery in the SmartKeyis screwed in tightly.

Check that the batteries in the SmartDoorare fresh.

If the condition persists, check that there are no radio-frequency transmitting devices or electronic devices that radiate electrical energy, which may interfere with the operation of the SmartDoor.

www.petsafe.net

11

Image 11
Contents Model Numbers PPA11-10711 Small, PPA11-10709 Large Operating Guide Guide d’emploi Guia para el usoImportant Safety Information Table of Contents Level Tape Pencil String ComponentsTools Needed How the SmartDoor WorksOperational Modes Outer Frame Size Overall pet door dimensionsPreparing Your SmartDoor PreparePlace Batteries in the SmartDoor Place Battery in the SmartKeyCheck Operational Modes Before Installation Operational IndicatorsDetermine Pet Door Location Installing Your SmartDoorInstall Check SmartDoor Location Before InstallationPreparing Door Cut Pet Door OpeningRe-hang door and place interior frame with Install Pet DoorStep Insert Screws Step Train Your PetUnderstanding Sensitivity and the Active Area Setting SmartDoor’s Sensitivity LevelSET Operating Your SmartDoor OperateProgramming a New SmartKey Attach the SmartKey to the Pet’s CollarComponent Part Number Replacement Parts and AccessoriesRevert SmartKey to Default Factory Setting Clear SmartKey MemoryCompliance Perchlorate Battery Important Recycling AdviceBattery Disposal Terms of Use and Limitation of LiabilityAustralia Même la mort Importante information de sécuritéPréparation Table des matièresComment fonctionne la SmartDoor ComposantsOutils nécessaires Modes de fonctionnement Définitions clefsPréparation Installez les piles dans la SmartDoorInstallez a pile dans la SmartKey Préparation de votre SmartDoorModes de fonctionnement Vérification lendroit de la SmartDoor avant linstallationÉtape Préparation de la porte Installation de votre SmartDoorInstallation Étape Déterminez le lieu dinstallation de la chatièrePour la scie sauteuse Installation de la chatièreCoupez louverture pour la chatière Réglage du niveau de sensibilité de la SmartDoor Étape Insérez les visÉtape Entraînement de votre animal Réglage~ 76 cm 2,5 pi ~ 183 cm 6 pi Compréhension la sensibilité et de la zone activeFonctionnement de votre SmartDoor FonctionnementProgrammation dune nouvelle SmartKey Fixez la SmartKey au collier de votre animalEffacer la mémoire SmartKey Pièces de remplacement et accessoiresRétablir la SmartKey aux réglages par défaut Composant Numéro de pièce Service à la clientèle InternationalPile perchlorate Conditions dutilisation et limitation de responsabilitéCC/Canada Avis de recyclage importanteMise au rebut de pile ConformitéInformación importante sobre seguridad Preparación Tabla de contenidoNivel Cinta Lápiz Hilo ComponentesHerramientas necesarias Cómo funciona el receptor SmartDoorModos de funcionamiento Definiciones claveColoque la batería en el transmisor SmartKey Prepare el receptor SmartDoorPreparación Coloque las pilas en el receptor SmartDoorModos de funcionamiento Para mascotas InstalaciónCómo instalar el receptor SmartDoor Seleccione el lugar donde instalará la puertaConsejo útil Utilice una sierra con la hoja Instale la puerta para mascotasCorte el hueco donde se colocará la puerta para mascotas Mascotas encaje correctamentePaso Coloque los tornillos Configuración~ 2,5 pies 76 cm ~ 6 pies 183 cm Para comprender el área activa y de sensibilidadConsulte el punto B Color de la luz Situación FuncionamientoCómo programar un transmisor SmartKey nuevo Cómo funciona el receptor SmartDoorCómo borrar la memoria del transmisor SmartKey Piezas y accesorios de repuestoComponente Número de pieza Atención al Cliente InternacionalComisión Federal de Comunicaciones/Canadá Pilas de perclorato Aviso importante sobre recicladoEliminación de las pilas CumplimientoAustralia Radio Systems Corporation

PPA11-10709, PPA11-10711 specifications

The PetSafe PPA11-10709 and PPA11-10711 are innovative pet training collars designed to enhance the training experience for both dogs and their owners. These products incorporate advanced features and technologies to ensure effective communication between you and your pet.

The PPA11-10709 collar is known for its lightweight design, making it comfortable for dogs of various sizes. It includes a range of training modes, allowing owners to choose the best method for their pet. The adjustable static stimulation levels provide a customizable training experience, enabling users to select the appropriate intensity for their dog's sensitivity. Additionally, this collar boasts a waterproof design, ensuring it continues to function effectively, even in wet conditions.

On the other hand, the PPA11-10711 model emphasizes a more advanced training experience. It offers a combination of audible tones and vibrations, catering to pets that may respond better to these forms of communication rather than solely static stimulation. This model also comes with a longer battery life, ensuring that training sessions can continue uninterrupted. The durable construction makes it suitable for active dogs, providing a reliable solution for both indoor and outdoor training.

Both models incorporate PetSafe’s innovative technology that ensures consistent signal transmission, reducing the chances of miscommunication during training. The collars are compatible with various PetSafe training accessories, allowing users to expand their training toolkit to meet their dog’s unique needs.

Moreover, the easy-to-read instructional manual and user-friendly interface make the setup process simple, allowing even first-time pet owners to get started with training quickly. The ergonomic design also enables owners to adjust the collar comfortably on their pets, ensuring it fits securely without causing discomfort.

In conclusion, the PetSafe PPA11-10709 and PPA11-10711 collars are excellent tools for effective dog training. By integrating customizable training modes, waterproof features, and durable materials, these collars reflect PetSafe's commitment to providing quality products that facilitate positive pet behavior. Whether you’re looking for a straightforward training collar or a more advanced system, these models deliver the functionality and reliability that every pet owner seeks.