Inputs > Commands >
Set Part 2 Zones | MENU |
This menu allows you to program which zones are to be monitored when an area has been turned Part 2 On.
Enter programming mode (PIN + MENU) then,
1.Enter [MENU] + [3] + [0] + [4].
A list of areas will display on the keypad.
2.Use the [↑] and [↓] keys to select the area that you want to program zones for Part 2 On, then press [OK]. Alternatively, you can enter the area number that you want to program Part 2 On zones, then press [OK].
The keypad will list all zones that can be programmed for Part 2 On. A ‘’ displayed on the right side of the zone name indicates that the zone is already bypassed.
Z001 Zone 1 Name
Z002 Zone 2 Name
Z003 Zone 3 Name
Press OK or MENU
3.Use the [↑] and [↓] keys to select the zone that you want to set for Part 2, then press [OK]. Alternatively, you can enter the zone number that you want to set for Part 2, then press [OK].
If the zone is not programmed for Part 2, the keypad will prompt:
Zone 1 Z001
Is not a PART2 Zone,
To Enable, Press ON.
To Go Back Press OK
If the zone is programmed for Part 2, the keypad will prompt:
Zone 1 Z001
Is a PART2 Zone,
To remove, Press OFF.
To Go Back Press OK
4.Press [ON] to monitor the zone when the area is turned Part 2 On, or press [OFF] so that you do not monitor the zone when the area is turned Part 2 On.
5.Press [OK] to save and exit, or press [MENU] to exit without saving.
| Solution 64 User Guide | |
Inputs > Commands > |
|
|
Smoke Sensor Reset |
| MENU |
This menu allows you to reset smoke sensors.
Enter programming mode (PIN + MENU) then,
1.Enter [MENU] + [3] + [0] + [5].
A list of different areas will display on the keypad.
2.Use the [↑] and [↓] keys to select the area that you want to reset the smoke detectors, then press [OK] to select. Alternatively, you can enter the area number, then press [OK].
The keypad will display the following:
Smoke detector reset in
Progress. Please wait
3.The keypad will automatically return to the menu when all smoke detectors in the area has been reset.
Inputs > Zone Properties >
Zone Name | MENU |
This menu allows you to program up to 16 characters for the name of each zone.
Enter programming mode (PIN + MENU) then,
1.Enter [MENU] + [3] + [1] + [0].
A list of different zones will display on the keypad.
2.Use the [↑] and [↓] keys to select the zone name that you want to change, then press [OK] to select. Alternatively, you can enter the zone number, then press [OK].
The keypad will display the following:
Zone Name Z001
Zone 1 Name
Press ◄► OK to SAVE
3.Use the [←] and [→] keys to scroll the cursor left and right across the zone name text. Use the [↑] and [↓] keys to scroll through the different characters available. To clear all text from the cursor position to the right, press the [OFF] key.
4.Press [OK] to save and exit, or press [MENU] to exit without saving.
Bosch Security Systems |
| 09/06 |
| BLCC110U | 17 |
|
|