Solution 64 
User Guide
Outputs > Output Testing >
External Siren Test | MENU |
This menu allows you to test any external sirens which have been connected by your installer. The test will last for 5 seconds.
Enter programming mode (PIN + MENU) then,
1.Enter [MENU] + [4] + [9] + [0].
If the system has been partitioned, the keypad will display a list of areas.
A001 Area 1 Name
A002 Area 2 Name
A003 Area 3 Name
PRESS OK or MENU
2.Use the [↑] and [↓] keys to select the area that you want to test the siren, then press [OK]. Alternatively, you can enter the area number, then press [OK].
The keypad will display the following during the siren test.
External Audible Testing Press any key to abort
Press OK or MENU
When the siren test is complete, the keypad will display the following:
Testing Complete. Press
OK to continue
Press OK or MENU
3. Press [OK] to exit. Outputs > Output Testing >
Internal Siren Test | MENU |
This menu allows you to test any internal sirens which have been connected by your installer. The test will last for 5 seconds.
Enter programming mode (PIN + MENU) then,
1.Enter [MENU] + [4] + [9] + [1].
If the system has been partitioned, the keypad will display a list of areas.
A001 Area 1 Name
A002 Area 2 Name
A003 Area 3 Name
PRESS OK or MENU
2.Use the [↑] and [↓] keys to select the area that you want to test the bell, then press [OK]. Alternatively, you can enter the area number, then press [OK].
The keypad will display the following during the bell test.
Internal Audible Testing
Press any key to abort
Press OK or MENU
When the bell test is complete, the keypad will display the following:
Testing Complete. Press |
|
OK to continue |
|
Press OK or MENU |
|
3. Press [OK] to exit. |
|
Outputs > Output Testing > |
|
Strobe Test | MENU |
This menu allows you to test the external strobe light. Enter programming mode (PIN + MENU) then,
1.Enter [MENU] + [4] + [9] + [2].
If the system has been partitioned, the keypad will display a list of areas.
A001 Area 1 Name
A002 Area 2 Name
A003 Area 3 Name
PRESS OK or MENU
2.Use the [↑] and [↓] keys to select the area that you want to test the strobe, then press [OK].
Alternatively, you can enter the area number, then press [OK].
The keypad will display the following during the strobe test.
Strobe Activated. Will
Reset On exit
Press OK or MENU
Check and verify that the strobe light is on.
3.Press [OK] to exit.
20 | Bosch Security Systems |
09/06
BLCC110U