System Configuration | 3M Library Security System | |
|
|
|
3.13Turning Your System On
The 3Mt Detection System Model 3501/3502 is designed to be left on continuously.
To turn on, connect the Electronics Enclosure power cord to a power outlet. Turn the On/Off key switch to ON. The Power On indicator light should be on.
Allow 15 seconds for the system to start up.
3.14How to Verify System Operation
Your 3Mt Detection System Model 3501/3502 should be inspected daily for proper operation.
Proper system operation is indicated when the red power indicator light is illuminated. System operation may be verified by passing through the system with a marked book, which should result in an audible alarm and a light on at the top of the panels. Each pass through the system should also increment the counter by one. The alarm/inhibit light on the Electronics Enclosure should also be illuminated (green) at the time of alarm. If the system does not respond, see the Troubleshooting Guide in Section 6.
There is no need for repetitive
E 3M 1999 September |