
3M Accessories | 3M Library Security System |
|
|
Note
Multiple passes are not required to resensitize an item unless the indicator light did not turn on, then off.
Wrong Direction
Center Start
Spine of Material not against Model 764
Resensitizing Compact Disks (CDs)
The procedure for resensitizing CDs is the same as for books, except: the CD must be positioned upright as shown below and two passes must be made.
1.Pass the CD across the front surface of the Model 764 once.
2.Rotate the CD clockwise or counterclockwise 180 degrees so the bottom is now on top.
3.Pass the CD across the Model 764 a second time.
Troubleshooting
4.The Model 764 has been designed for a comfortable processing speed. The photocell must be unblocked for a short time (approximately 1.5 seconds) between books.
5.The speed with which material is processed can be increased by stacking printed materials up to the height of the vertical front surface of the unit. This is especially helpful for thin materials such as periodicals.
Indicator Light
Photocell
If the indicator light will not turn on during a proper pass, check the power connection for the Model 764. If the power connection is good, disconnect the power cord from the unit, pull out the fuse holder and check the fuse. A spare fuse is provided with each new Model 764. This unit is not otherwise operator serviceable.
!Caution
This unit is not designed to work with Magnetic Media. To prevent possible damage or loss of information, keep all such items at least 6 inches away from the Resensitizer.
E 3M 1999 September |