Heat & Glo LifeStyle BE-41 manual MAX .4 M, Straight Up Vertical Venting

Page 13

STRAIGHT UP
VERTICAL VENTING
	V (FT.)
40' MAX. (12.4 M)
Figure 6.	Straight Up Vertical Venting

NOTE: On vertical venting configurations where the vertical component is over 10 feet, you may want to install the vertical baffle (VERT-BAF) (see Figure 7).

	5” EXHAUST
	PIPE
	VERTICAL
	BAFFLE
	CENTER VERTICAL
	BAFFLE ON 5”
	EXHAUST PIPE
Figure 7.	Vertical Baffle

NOTE: Center the vertical baffle over the 5” exhaust pipe. Fasten in place with self tapping screws.

HORIZONTALVENTING

Kit No. H Max. Run

DVK-01D

DVK-01TRD 24" (610 mm)

H

90-DEGREE ELBOWS

45-DEGREE

ELBOW

NOTE: BE-41 model is tested and approved to use 45° elbows in corner installations. However, 90° elbows will result in better per- formance.

Figure 8. Corner Installation

13

Image 13

Contents What to do if you smell gas Installers GuideSafety and Warning Information Table of Contents Service Parts LOGS-BE41 BE-41 Service Parts List / Liste des pièces de rechangeInstallation Codes High Altitude InstallationsAppliance Certification CertificationIntroducing the Heat-N-Glo Gas Fireplaces Pre-install PreparationANY Such Action MAY Possibly Cause a Fire Hazard GAS Line AccessLocating the Fireplace Fireplace Dimensions, LocationsSpace Requirements Clearance Requirements Framing the Fireplace Framing DimensionsAT Each Joint Vent System Approvals Installing the Vent SystemIdentifying Vent Components Terminations KitsMAX .4 M Vertical VentingStraight Up Vertical Venting Venting with One 90 Elbow Venting with ONE 1 90 ElbowVenting with TWO Elbows Venting with three 90 elbows Venting with Three 3 90 Elbows+ H 1 FT Venting Out the Rear Vent Installing Vent ComponentsVenting Out the Top Vent Attach the First Vent Component to the Starting CollarsContinue Adding Vent Components Install Support Brackets12 Hole and Vent Pipe Attic Firestop Vent TerminationMinimum for vinyl clad soffits =VENT Terminal =AIR Supply InletMinimum Height from Roof to Lowest Discharge Opening Gas Control Systems Positioning, Leveling, Securing the FireplaceLeveling and Securing of a Fireplace Standing Pilot Ignition SystemGas Pressure Requirements Gas Supply LineFor Standing Pilot Ignition Wiring Appliance Requirements Wiring the FireplaceOptional Accessories Remote Wall SwitchInstalling the Trim Installing Trim, Logs, and Ember MaterialFinishing Hearth ExtensionsPositioning the Logs BeforeLog Placement Tabs Before Lighting the Fireplace After the InstallationLighting the Fireplace TemperedImportant Turn OFF the GAS Before Servicing Your Fireplace Fireplace Maintenance