Heat & Glo LifeStyle BE-41 Positioning, Leveling, Securing the Fireplace, Gas Control Systems

Page 24

Step 4. Positioning, Leveling, and

Securing the Fireplace

The diagram below shows how to properly position, level, and secure the fireplace.

Figure 27. Proper Positioning,

Leveling and Securing of a Fireplace

•Place the fireplace into position.

•Level the fireplace from side to side and front to back.

•Shim the fireplace with non-combustible material, such as sheet metal, as necessary.

•Secure the fireplace to the framing by nailing or screwing.

Step 5. The Gas Control Systems

!WARNING: THIS UNIT IS NOT FOR USE WITH SOLID FUEL.

The type of gas control system used with this model is: Standing Pilot Ignition.

Standing Pilot Ignition System

This system includes millivolt control valve, standing pilot, thermopile/thermocouple flame sensor, and piezo ignitor.

!WARNING: 110-120 VAC MUST NEVER BE CONNECTED TO A CONTROL VALVE IN A MILLIVOLT SYSTEM.

Figure 28.

Gas Controls Systems

24

Image 24

Contents Installers Guide What to do if you smell gasSafety and Warning Information Table of Contents Service Parts BE-41 Service Parts List / Liste des pièces de rechange LOGS-BE41High Altitude Installations Installation CodesAppliance Certification CertificationPre-install Preparation Introducing the Heat-N-Glo Gas FireplacesGAS Line Access ANY Such Action MAY Possibly Cause a Fire HazardFireplace Dimensions, Locations Locating the FireplaceSpace Requirements Clearance Requirements Framing Dimensions Framing the FireplaceAT Each Joint Installing the Vent System Vent System ApprovalsIdentifying Vent Components Terminations KitsVertical Venting MAX .4 MStraight Up Vertical Venting Venting with ONE 1 90 Elbow Venting with One 90 ElbowVenting with TWO Elbows Venting with Three 3 90 Elbows Venting with three 90 elbows+ H 1 FT Installing Vent Components Venting Out the Rear VentVenting Out the Top Vent Attach the First Vent Component to the Starting CollarsInstall Support Brackets Continue Adding Vent Components12 Hole and Vent Pipe Vent Termination Attic Firestop=VENT Terminal =AIR Supply Inlet Minimum for vinyl clad soffitsMinimum Height from Roof to Lowest Discharge Opening Positioning, Leveling, Securing the Fireplace Gas Control SystemsLeveling and Securing of a Fireplace Standing Pilot Ignition SystemGas Supply Line Gas Pressure RequirementsWiring the Fireplace For Standing Pilot Ignition Wiring Appliance RequirementsOptional Accessories Remote Wall SwitchInstalling Trim, Logs, and Ember Material Installing the TrimFinishing Hearth ExtensionsBefore Positioning the LogsLog Placement Tabs After the Installation Before Lighting the FireplaceLighting the Fireplace TemperedFireplace Maintenance Important Turn OFF the GAS Before Servicing Your Fireplace