Heat & Glo LifeStyle BE-41 manual Log Placement Tabs

Page 29

5.The grate is located in the lower cav- ity. Remove the screw holding the grate in place and discard the screw.

6.Position the grate into the cutout in the refractory. Hook the grate into po- sition using the tabs on the bottom of the grate. Make sure the grate is pulled forward on the refractory (see Figure 37).

7.Cut shrink wrap and remove from around the log assembly.

!WARNING: REMOVE ALL PACKAGING FROM LOGS.

8.Install embers. See ember placement instructions for details.

!WARNING: USE DIME SIZE PIECES ONLY. DO NOT COVER PORTS.

9.Carefully position the log set in place into the fireplace. Pull the log set for- ward until the log set contacts the log placement tabs. Center the log set in the firebox side to side (see Figure 38). (Grate removed for viewing.)

Figure 37

Log Placement Tabs

Figure 38

29

Image 29

Contents What to do if you smell gas Installers GuideSafety and Warning Information Table of Contents Service Parts LOGS-BE41 BE-41 Service Parts List / Liste des pièces de rechangeInstallation Codes High Altitude InstallationsAppliance Certification CertificationIntroducing the Heat-N-Glo Gas Fireplaces Pre-install PreparationANY Such Action MAY Possibly Cause a Fire Hazard GAS Line AccessSpace Requirements Clearance Requirements Fireplace Dimensions, LocationsLocating the Fireplace Framing the Fireplace Framing DimensionsAT Each Joint Vent System Approvals Installing the Vent SystemIdentifying Vent Components Terminations KitsStraight Up Vertical Venting Vertical VentingMAX .4 M Venting with One 90 Elbow Venting with ONE 1 90 ElbowVenting with TWO Elbows Venting with three 90 elbows Venting with Three 3 90 Elbows+ H 1 FT Venting Out the Rear Vent Installing Vent ComponentsVenting Out the Top Vent Attach the First Vent Component to the Starting CollarsContinue Adding Vent Components Install Support Brackets12 Hole and Vent Pipe Attic Firestop Vent TerminationMinimum for vinyl clad soffits =VENT Terminal =AIR Supply InletMinimum Height from Roof to Lowest Discharge Opening Gas Control Systems Positioning, Leveling, Securing the FireplaceLeveling and Securing of a Fireplace Standing Pilot Ignition SystemGas Pressure Requirements Gas Supply LineFor Standing Pilot Ignition Wiring Appliance Requirements Wiring the FireplaceOptional Accessories Remote Wall SwitchInstalling the Trim Installing Trim, Logs, and Ember MaterialFinishing Hearth ExtensionsPositioning the Logs BeforeLog Placement Tabs Before Lighting the Fireplace After the InstallationLighting the Fireplace TemperedImportant Turn OFF the GAS Before Servicing Your Fireplace Fireplace Maintenance