SET
To adjust anticipation, press CLOCK and
ADVDAY at the same time. The display will show
HEAT 5 (this is the factory preprogrammed heating anticipation setting). You may se- lect any anticipation setting from 4 to 40. If
the heat cycles are too short, press TIMEFWD to
increase the cycle time. If the heat cycles
are too long, press BACKTIME to decrease the cycle time. To set cooling anticipation, press
CLOCKSET and ADVDAY at the same time again. The display will show COOL 14 (factory preprogrammed cooling anticipation).
Press TIMEFWD or BACKTIME to adjust anticipation.
Press PRGMRUN to return to your program.
•LOW BATTERY INDICATOR — The word BATTERY will flash on the display if the 9 volt alkaline battery is low and should be replaced.
•AUDIO PROMPTING — Each time you press a button, the thermostat will beep (this feature works only when the thermo- stat is attached to the wall and 24VAC power is present to the thermostat).
•BACKLIT DISPLAY — When you press any button on the thermostat, the display is lit for approximately eight seconds (this feature works only when the thermostat is attached to the wall and 24VAC power is present to the thermostat).
•COMPRESSOR SHORT CYCLE PRO- TECTION — To protect your compressor from potential damage due to rapid cy- cling, this thermostat has a
16