EMR on, Mostat back on the wall. Press

displayed. If the switch is OFF (down), use a pencil or small screwdriver to move the switch to the ON position (see figure be- low). Remove the battery for at least two minutes, to allow the thermostat to reset itself. Replace the battery and put the ther-

mostat back on the wall. Press	SYSTEM
	SWITCH

until the desired operating mode is dis- played.

EMR (ON)

1 2 3 4

Switch #1 set at installation (DO NOT CHANGE) Switch #2 set at installation (DO NOT CHANGE) Switch #3 ON

Switch #4 (see TOTAL KEYPAD LOCKOUT)

To disable EMR, press	SYSTEM	until OFF
	SWITCH

is displayed. Remove the thermostat body from the wall and use a pencil or small screwdriver to move option switch #3 to the OFF (down) position. Remove the battery and allow at least two minutes for the thermostat to reset itself. Replace the bat-

tery, press	SYSTEM	until OFF is displayed,
	SWITCH

then replace the thermostat on the wall.

Press	SYSTEM	until the desired operating
	SWITCH

mode is displayed.

•AUTOMATIC CHANGEOVER — If your thermostat was configured for this option at installation, you can set the thermostat to automatically switch the system from heating to cooling as needed. Press

SYSTEM	to set the thermostat to AUTO (the
SWITCH

mostat back on the wall. Press

EMR (ON)

until OFF