14
INSTALLATION
Checking Gas Connections (Cont.) Installing Logs
INSTALLATION |
Continued |
Gas Control Valve |
Equipment Shutoff Valve
Gas Meter
1. | Place front log (#1) on top of the grate. Make sure the notches |
| in the bottom of the log fit over the grate prongs (see Figure |
| 24). Push back of log flush with metal grate bar. |
2. | Rest middle log (#2) behind metal posts on front burner. Make |
| sure the grooves in the bottom of the log fit over the grate. |
| Bring the log forward next to the metal posts (see Figure 25). |
3. | Slide the grooves in the back of the rear log (#3) against the |
| rear grate prongs. Make sure the peg on the log is on top (see |
| Figure 26). |
4. | Place the crossover log (#4) on the rear log and the middle log. |
| Make sure the peg on the rear log is in the hole in the bottom |
| of the crossover log. The crossover log should fit in the cutout |
| of the middle log (see Figure 27). |
Figure 22 - Checking Gas Joints for Natural Gas
Equipment |
| |
Shutoff | Propane/LP | |
Valve | ||
Supply | ||
| ||
| Tank | |
Gas Control Valve |
|
Figure 23 - Checking Gas Joints for Propane/LP Gas
INSTALLING LOGS
WARNING: Failure to position the parts in accor- dance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.
CAUTION: Do not remove the metal data plates attached to the heater base assembly. The data plates contain important safety and warranty information.
Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.
5. Install fireplace screen by slipping notches of fireplace screen |
over screws on front of fireplace (see Figure 28, page 15). |
WARNING: You must operate this fireplace with the fireplace screen in place. Make sure fireplace screen is in place before running fireplace.
|
|
| Middle Log (#2) | |
Front Log (#1) |
|
| Groove | |
|
| Groove |
| |
Notch |
| Metal |
| |
| Post |
| ||
|
|
| ||
Grate |
|
|
|
|
Prongs |
|
|
|
|
Metal Grate Bar |
|
| Metal Post | Grate |
Figure 24 - Installing Front | Figure 25 - Installing Middle | |||
Log (#1) |
| Log (#2) |
| |
Peg | Rear Log |
|
| Crossover |
Groove | (#3) |
|
| Log (#4) |
in Back | Groove |
|
| |
in Back |
| Hole | ||
of Log |
| |||
Grate | of Log | Cutout |
| |
|
| Peg | ||
Prong |
|
|
| |
Grate |
|
| ||
|
|
| ||
| Prong |
|
| |
Rear
Burner
Figure 26 - Installing Rear | Figure 27 - Installing Crossover |
Log (#3) | Log (#4) |
For
visit
.
.com
107172