Optional Blower Operation, GHRCTA Series Operation

OPERATING FIREPLACE

Optional Remote Operation (Cont.) Optional Blower Operation

OPERATING FIREPLACE

Continued

GHRCTA Series Operation:

2b. Press the AUTO/ON/OFF button on the hand-held remote control (see Figure 33). The lights to the left of the button

		Increases Room
	Shows Temperature	Temperature in
	Shows Temperature	AUTO Mode
	Setting	AUTO Mode
	Setting

will show AUTO, ON, or OFF.

• In the ON mode, the burners will ignite. The heater is in

manual mode when ON is lit.

• In the AUTO mode, the thermostat in the hand-held remote

unit controls the room temperature. To increase the room

temperature, press the top arrow of the TEMP button. To

lower the room temperature, press the bottom arrow of the

TEMP button. At higher settings the heater will run longer.

IMPORTANT: This remote control has been specially en-

gineered to take an air temperature sample every minute

The Log Heater will Automatically Cycle between Pilot and the Heat Setting that has been Selected

Decreases Room

Temperature in

AUTO Mode

Turns Burners On or Off and Allows You to Choose the Auto Setting

in the auto mode. It will not respond immediately to the

temperature setting being turned up or down.

IMPORTANT: The hand-held remote control unit must

be near the fireplace. Do not keep the hand-held remote

control unit too close to the fireplace. The thermostat on

the hand-held remote control unit will heat up too quickly

and turn the fireplace off.

3. To turn the burners off, press the AUTO/ON/OFF button

until OFF lights. The pilot will remain lit.

IMPORTANT: To turn the pilot off, manually turn the con-

trol knob on the fireplace to the OFF position.

	Flame Adjustment Knob
ON				OL
	N

OFF	O			O

REMOTE	T		F
	O
			F	HI
	LIP
Selector Switch in Remote		Control Knob in
		On Position
Position (Optional Remote

Control)

Figure 32 - Setting the Selector Switch, Control Knob, and Flame Adjustment Knob for Remote Operation

Figure 33 - Thermostat Hand-Held Remote Control Unit Selections (GHRCTA Series Only)

OPTIONAL BLOWER OPERATION

WARNING: This fireplace has a three-prong, grounded electrical plug. This plug helps protect you against electrical shock. Only connect plug to a properly grounded, three-prong receptacle. Do not cut or remove the grounding prong from this plug.

Locate the blower switch by opening lower louver on fireplace. Blower switch is located at lower left inside louver door.

The GA3700TA thermostat-controlled blower has a variable speed control with an ON/OFF switch. The blower will start when the thermostat senses a sufficient increase in firebox temperature. The GA3700 variable speed blower also has an ON/OFF switch built into the variable speed control.

Note for GA3700TA Only: If you are using GA3700TA blower, your fireplace and blower will not turn on and off at the same time. The fireplace may run for several minutes before the blower turns on. After the heater modulates to the pilot position, the blower will continue to run. The blower will shut off after the firebox temperature decreases.

Note: It is safe to operate fireplace with blower turned off. However, the blower helps distribute heated air from the fireplace.

Follow installation instructions included with the blower accessory.

For morevisit www..com

107172