14
INSTALLATION
Installing Blower Accessory GA3450T in
INSTALLATION
Continued
3.A licensed electrician must follow the wiring diagram to con- nect incoming electrical supply to fan kit wiring harness (see Figure 19).
4.Plug power cord to the outlet receptacle (not provided) as shown in Figure 20. Wind the extra cable in power cord and and tie it up with the plastic wire strap (see Figure 20). Set the cable bundle between the burner bracket and outer casing, away from the burner.
5.Test to make sure the blower is working properly.
6.Reinstall upper louver assembly (see Figure 15, page 12) and close lower louver.
| Fan Switch |
|
|
|
|
|
| ||||
| (Auto/Off/On) |
|
|
|
|
|
| ||||
|
| 1 Auto |
|
|
|
|
|
| |||
| Off | 2 |
|
|
|
|
|
|
|
|
|
|
| 3 | Blue |
| Thermostat | ||||||
|
|
| On |
|
|
| Switch | ||||
|
|
|
|
|
| (N.O.) | |||||
110/115 |
|
| Red |
|
|
|
| Blue | |||
V.A.C. |
|
|
|
| Blower | ||||||
| Black |
|
|
|
|
|
|
|
| Motor | |
|
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
| Red |
| |||
| White |
|
|
|
|
|
| White |
| ||
| Green |
|
|
|
|
|
| Green | |||
Extension Cord
Use extension cord if needed. The cord must have a
INSTALLING OPTIONAL BLOWER ACCESSORY GA3450T IN THERMOSTAT- CONTROLLED MODELS
Removing Upper Louver Assembly
To install the blower accessory, you must first remove the upper louver assembly.
1.Remove 4 screws from upper louver assembly (see Figure 21). Save these screws.
2.Pull upper louver assembly straight out from the cabinet. Be care- ful not to scratch the paint. Set louver assembly and screws aside.
Figure 19 - Wiring Diagram For Blower Accessory Built-In Installation
Blower Bracket |
|
Assembly | Wire Harness |
Screw
Switch | Power | Outlet Receptacle | |
Cord | |||
| (Not Supplied) | ||
|
|
Blower Bracket
Mounting Holes
Brass
Screws
Upper Louver Assembly
Switch
Plate Blue
Black
Red | Plastic |
| |
| Wire Strap |
Wire Harness | Clamp Connector |
| |
| (not included) |
| Lower Louver Door |
Figure 20 - Installing Blower Bracket Assembly
Figure 21 - Removing Upper Louver Assembly
For
.
.com
