Desa EFS26NR, FMH26PR Optional Wireless HAND-HELD Remote Control Accessories, Installing Receiver

20

INSTALLATION

Checking Gas Connections (Cont.)

Optional Wireless Hand-Held Remote Control Accessories [Remote-Ready Models Only]

INSTALLATION

Continued

3.Check all joints from gas meter to equipment shutoff valve for natural gas or propane/LP supply to equipment shutoff valve for propane/LP (see Figures 34 or 35). Apply noncorrosive leak detection fluid to all joints. Bubbles forming show a leak.

4.Correct all leaks at once.

OPTIONAL WIRELESS HAND-HELD REMOTE

CONTROL ACCESSORIES

Remote-Ready Models Only

(GHRC Series & GHRCTA Series)

Pressure Testing Fireplace Gas Connections

1.Open equipment shutoff valve (see Figure 33, page 19).

2.Open main gas valve located on or near gas meter for natural gas or open propane/LP supply tank valve.

3.Make sure control knob of fireplace is in the OFF position.

4.Check all joints from equipment shutoff valve to gas regulator (Thermostat-Controlled Models), or to gas control valve (Remote- Ready Models) (see Figures 34 or 35). Apply noncorrosive leak detection fluid to all joints. Bubbles forming show a leak.

5.Correct all leaks at once.

6.Light fireplace (see Operating Fireplace, pages 23 through 27). Check all other internal joints for leaks.

7.Turn off fireplace (see To Turn Off Gas to Appliance, page 24 for Thermostat-Controlled Models or page 25 for Remote- Ready Models).

Equipment	Gas Regulator or
	Gas Control Valve
Shutoff Valve

Propane/LP

Supply

Tank

Installing Receiver

1.Remove screws.

2.Disconnect switch wires from the control valve.

3.Remove switch plate (see Figure 36). Discard switch plate after removing. Save the screws.

4.Locate the battery clip mounted on the back of the receiver (see Figure 37).

5.Slide 9-volt battery (not included) through the clip.

6.Attach the terminal wires to the battery (see Figure 37).

7.Connect wires as shown in Figure 38, page 21.

8.Install remote receiver unit onto fireplace base using the two screws removed in step one (see Figure 38, page 21).

Switch Plate

Screw

Red Wire

Black Wire

Figure 36 - Switch Plate and Wiring Harness

Receiver

Figure 34 - Checking Gas Joints (Propane/LP Only)
Gas Regulator or
Gas Control Valve
Equipment	Terminal
Shutoff Valve
	Wires
	Battery Clip
Gas Meter	9-Volt Battery
	Figure 37 - Attaching Battery to Receiver
Figure 35 - Checking Gas Joints (Natural Gas Only)

For..com

107032-01E