26
OPERATING FIREPLACE
Optional Remote Operation
GWMT1 Wall Mounted Thermostat (Optional)
OPERATING FIREPLACE
Continued
OPTIONAL REMOTE OPERATION
Note: All remote control accessories must be purchased sepa- rately (see Accessories, pages 38 and 39). Follow instructions included with the remote control.
Thermostat Control Operation
(Optional GHRCTA Series Only) The thermostat control set- ting on the remote control unit can be set to any comfort level between WARMER and COOLER. The burners will turn on and off automatically to maintain the comfort level you select. The ideal comfort setting will vary by household depending upon the amount of space to be heated, the output of the central heating system, etc.
For wall thermostat operation, follow instruction supplied with thermostat accessory GWMT1. For wall switch operation fol- low instructions supplied with GWMS2.
NOTICE: You must light the pilot before using the remote control unit. See Lighting Instructions on page 25.
1. After lighting, let pilot flame burn for about one minute. |
Turn control knob to ON position. Adjust flame adjust- |
ment knob anywhere between HI and LO. Slide the selec- |
tor switch to the REMOTE position. Note: The burner may |
light if |
switch was last turned off. You can now turn the burner on |
GHRCTA Series Operation:
2b. Press the AUTO/ON/OFF button on the
•In the ON mode, the burners will ignite. The fireplace is in manual mode when ON is lit.
•In the AUTO mode, the thermostat in the
IMPORTANT: This remote control has been specially engi- neered to take an air temperature sample every 5.5 minutes in the auto mode. It will not respond immediately to the tem- perature setting being turned up or down.
IMPORTANT: The
3.To turn the burner off, press the AUTO/ON/OFF button un- til OFF lights. The pilot will remain lit.
IMPORTANT: To turn the pilot off, manually turn the con- trol knob on the heater to the OFF position.
and off with the |
IMPORTANT: Do not leave the selector switch in the RE- |
MOTE or ON position when the pilot is not lit. This will |
drain the battery. |
IMPORTANT: Be sure to press the ON/OFF buttons on the |
hand held remote control unit for up to 3 seconds to assure |
proper operation. |
GHRC Series Operation:
2a. Press the ON/OFF button to turn the burners on and off. When turning burners off, the pilot will remain lit.
Shows
Temperature
Setting
The Log
Fireplace will
Automatically 
Cycle between
Pilot and the
Heat Setting that has been Selected
Increases Room
Temperature in
AUTO Mode
Decreases
Room
Temperature in
AUTO Mode
Turns Burners
On or Off and
Allows You to
Choose the Auto
Setting
Selector Switch in Remote |
|
| Control Knob |
Position (Optional Remote Control) |
|
| |
REMOTE |
|
| OL |
N |
|
| |
OFF |
|
| |
O | F O |
| |
ON | T |
| |
| O | F | HI |
| LIP |
|
Flame Adjustment Knob
Figure 52- Setting the Selector switch, Control Knob, and Flame Adjustment Knob for Remote Operation
Figure 53 - Thermostat Hand-Held Remote Control Unit Selections (GHRCTA Only)
GWMT1 WALL MOUNTED
THERMOSTAT (OPTIONAL)
Make sure the heater switch is on AUTO and set the temperature adjustment on wall thermostat to the desired setting. The ther- mostat has been electronically calibrated at the factory and requires no adjustment or leveling.
Upon installation, the thermostat must be allowed to stabilize at room temperature for a minimum of 30 minutes for proper operation. See installation instructions on page 21 of this manual.
For
.
.com
