Desa CGEFP33PRB, CGEFP33NRB, EFP33PRB, EFP33NRB For Recessed Installation, For Recessed Fireplace

Page 11

INSTALLATION

Continued

Note: If you choose to relocate the wall switch assembly, do so before final installation into a mantel or recessing into a wall. If you are installing an optional blower accessory, install it at the same time you relocate the wall switch assembly.

CAUTION: The wall switch assembly must never be mount- ed directly above the fireplace where heat may damage it. If you relocate wall switch assembly from lower fireplace cavity, it must be mounted either on side wall of mantel or on wall to side of fireplace.

For Recessed Installation

If fireplace is to be recessed into a wall (see Built-In Fireplace Installation, page 21), we recommend mounting wall switch assembly to left side of fireplace. The wall switch assembly should be mounted approximately 12" from left edge of fireplace and less than 60" from the floor. IMPORTANT: Do not locate wall switch assembly directly in front of wall stud - there must be room behind wall board for wires from switch. If you choose to locate wall switch assembly to right side of fireplace, the length of the cord restricts you to less than 6" from right edge of fireplace and less than 48" from floor.

For Mantel Installation

If fireplace is to be installed into a mantel, (see Conventional Fireplace Installation, page 20) the wall switch assembly may be mounted on either side of the mantel, facing to the side. Do not locate wall switch assembly anywhere on the front face of the mantel.

CAUTION: Be careful of gas lines and wiring when moving floor.

1.Determine the new location for the wall switch assembly. The wires attached to switch are six feet long.

2.Remove 2 screws securing plastic wall switch assembly to bracket in fireplace lower cavity. Save screws.

3.Remove wire tie holding coiled wire attached to wall switch assembly (see Figure 8).

4.Remove wall switch assembly from bracket.

5.Carefully pass wall switch assembly and cord through large elongated hole in rear of either left or right floor support bracket, depending on desired location of switch. Pass wall switch as- sembly and cord through 1.5" diameter hole in side of fireplace outer casing (see Figure 9).

6.Pull wall switch assembly and cord from fireplace making sure wall switch assembly will reach desired mounting location without straining cord assembly.

If you are mounting wall switch assembly to a wall, continue reading. If you are mounting your wall switch assembly to the side of the mantel, see page 12.

Burner

Outlet Firebox

Tube Bottom

Wire

Tie

Gas Control

Wall Switch

Valve

Assembly

Figure 8 - Relocating Wall Switch

Assembly

 

Hole in Floor

Hole in

Support Bracket

 

Outer

 

Casing

 

Wall Switch

 

Assembly

 

Figure 9 - Routing Wall Switch Assembly

Through Fireplace for Relocation

Mounting Wall Switch Assembly to Wall

for Recessed Fireplace

 

7.Create three openings on wall according to Template 1, page 41. This is best done by making a pattern to work with on your wall. Carefully cut page 41/42 from manual and tape paper template vertically onto wall at preferred location. Pierce the paper at the cen- ters of the 2 holes with a nail or sharp pencil, leaving a mark on the wall. Do the same at centers of the four circles near the corners of the rectangle.

111245-01B

www.desatech.com

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents CGEFP33PRB, CGEFP33NRB EFP33PRB, EFP33NRB Shown with optional Hearth base accessoryTable of Contents Safety Information Product Identification Fireplace Floor AssemblyUnpacking Product FeaturesLocal Codes Determining FRESH-AIR Flow for Fireplace Location AIR for Combustion VentilationProviding Adequate Ventilation Ventilation Air From Inside Building Ventilation AIRVentilation Air From Outdoors InstallationCheck GAS Type Electrical Hookup Installation ClearancesInstallation Sequence Removing Fireplace Screen and Floor AssemblyFor Mantel Installation Electrical Connections for Power CordRelocating Wall Switch Assembly For Recessed Fireplace For Recessed InstallationCutting Lines Mounting Wall Switch Assembly to Side of MantelMounting Blower to Firebox Installing Variable Speed Blower AccessoryLocation of Wiring Diagram Decal 3 from Blower Installing Switch and Cover Assembly and Speed Control Installing Thermostatic Blower AccessoryInstalling Bushings Operating the Blower Installing GAS Piping to Fireplace LocationInstallation Items Needed Propane/LP Connecting Fireplace to GAS SupplyNatural Test Pressures Equal To or Less Than 1/2 Psig 3.5 kPa Checking GAS ConnectionsTest Pressures In Excess Of 1/2 Psig 3.5 kPa Pressure Testing Fireplace GAS Connections Conventional Fireplace InstallationNailing Flanges BUILT-IN Fireplace InstallationRough Opening for Installing Wall Top Brass Trim Side Brass Trim Adjusting Set Screws Installing HoodInstalling Back Log #1 Cgefp Logs Shown Installing LogsOperating Fireplace Installing Battery Into RemoteInstalling Screen For Your Safety Read Before LightingControl Using Supplied Wall Switch AssemblyNormal Lighting Instructions To Turn OFF GAS To Appliance Manual Lighting Instructions for Electrical Power OutageShutting Off Heater Wireless Remote Control Main Burner Inspecting BurnersOptional Blower Operation Pilot Flame PatternLogs Cleaning MaintenanceBurner Injector Holder Pilot AIR Inlet HoleObserved Problem Possible Cause Remedy TroubleshootingSee Cleaning and Mainte Statement above Gas leak. See WarningWhen Gas Pressure Is Too Low SpecificationsService Hints Technical ServiceIllustrated Parts Breakdown Remote Control LOG Base Assembly Parts ListIllustrated Parts Breakdown KEY Part Number EFP33PRB EFP33NRB Description QTY Firebox Models CGEFP33PRB, CGEFP33NRB, EFP33PRB and EFP33NRB KEY Part Number Description QTY Accessories Replacement PartsHearth Base for USE with Cabinet Mantel Corner Mantel Accessory with Fireplace Perimeter TrimCorner Hearth Base for USE with Corner Mantel Wiring Diagram Templates This page Intentionally Left Blank Parts Central 111245-01B 111245-01B Not a UPC

EFP33NRB, CGEFP33PRB, CGEFP33NRB, EFP33PRB, EFP33NRB specifications

Desa offers a range of premium electric fireplaces with models such as EFP33NRB, CGEFP33PRB, CGEFP33NRB, EFP33PRB, and EFP33NRB, each designed to blend aesthetics with advanced heating technology. These electric fireplaces are renowned for their ability to create a warm ambiance without the hassle of traditional wood or gas fireplaces.

The EFP33NRB model, a part of Desa's electric fireplace collection, features a sleek design that fits seamlessly into various interior styles. With its realistic flame effect and adjustable brightness settings, users can customize their experience, enhancing any room while maintaining a cozy atmosphere. This model also incorporates energy-efficient LED technology, ensuring minimal power consumption without compromising on the visual appeal and comfort.

Similarly, the CGEFP33PRB and CGEFP33NRB are designed for those who appreciate the combination of style and functionality. These models offer a robust heating output, capable of warming larger spaces efficiently. The innovative heat management system also ensures even heat distribution, making these units suitable for year-round use. Additionally, remote control capabilities allow for effortless adjustment, enhancing user convenience.

The EFP33PRB features a modern framework that showcases the flames within a stylish casing. Its user-friendly interface includes touch controls and an easy-to-read display, allowing users to change settings with ease. The fireplace boasts a range of flame colors, allowing for personalization to match any decor or mood.

Across all these models, safety remains a top priority with built-in overheat protection and a tip-over switch, providing peace of mind during operation. Furthermore, the fireplaces operate quietly, ensuring an undisturbed environment while creating a warm, inviting space.

In conclusion, the Desa EFP33NRB, CGEFP33PRB, CGEFP33NRB, EFP33PRB, and EFP33NRB models represent the pinnacle of electric fireplace technology. With their modern designs, efficiency, and flexibility, they offer a perfect solution for anyone looking to enhance their living spaces with warmth and style. Whether for a contemporary home or a cozy cabin, these fireplaces promise to deliver both comfort and elegance.
Top Page Image Contents