Desa CGEFP33PRB, CGEFP33NRB, EFP33PRB, EFP33NRB Installing GAS Piping to Fireplace Location

Page 17

INSTALLATION

Continued

16.Reattach fireplace floor assembly with screws removed in step 3 of Removing Fire- place Screen and Floor Assembly, page 9.

Note: Discard the remaining hardware items. After assembly, make sure all wires are com- pletely clear of blower wheel.

17.Install logs (see Installing Logs, page 24) and fireplace screen (see Installing Screen, page 25).

WARNING:Failuretoposition thepartsinaccordancewithsup- plied diagrams or failure to use only parts specifically approved with this heater may result in damage or personal injury.

WARNING: A qualified service person must connect fireplace to gas supply. Follow all local codes.

If any of the original wire as supplied with the appliance must be replaced, it must be replaced with 105˚C wire or it's equivalent.

Operating the Blower

After final installation of your fireplace, light your gas appliance with the blower off. After about 15 minutes, turn the blower on to deliver heated air at the top louvers. The blower features a variable control which allows you to select the speed you desire. In the OFF position, the blower will not operate. In the ON position, the blower will start when the thermostat senses a sufficient increase in firebox temperature (approximately 10 to 20 minutes depending on heat setting).

Your gas logs and thermostat blower will not turn on and off at the same time. The fireplace may run for several minutes before the blower turns on. After the heater modulates to the pilot position, the blower will continue to run. The blower will shut off after the firebox temperature decreases.

It is safe to operate fireplace with blower turned off. However, the blower helps distribute heated air from the fireplace.

Note: Periodically check the louvers of the firebox and remove any dust, dirt or other obstructions.

INSTALLING GAS PIPING TO FIREPLACE LOCATION

WARNING: A qualified service person must connect fireplace to gas supply. Follow all local codes.

WARNING: For propane/LP units, never connect fireplace directly to propane/LP supply. Thisfireplacerequiresanexternal regulator(notsupplied).Installthe external regulator between the heater and propane/LP supply.

WARNING: For natural gas units, never connect fireplace to private (non-utility) gas wells. This gas is commonly known as wellhead gas.

Installation Items Needed

Before installing fireplace, make sure you have the items listed below.

external regulator (supplied by installer, for propane/LP units only)

piping (check local codes)

sealant (resistant to propane/LP gas)

equipment shutoff valve *

test gauge connection *

sediment trap

tee joint

pipe wrench

approved flexible gas line with gas connector (if allowed by local codes) (not provided)

*A CSA design-certified equipment shutoff valve with 1/8" NPT tap is an acceptable alternative to test gauge connection. Purchase the optional CSA design-certified equipment shutoff valve from your dealer. See Accessories, page 40.

For propane/LP units, the installer must supply an external regulator. The external regulator will reduce incoming gas pressure. You must reduce incoming gas pressure to between 11 and 14 inches of water. If you do not reduce incoming gas pres- sure, heater regulator damage could occur. Install external regulator with the vent pointing down as shown in Figure 24, page 18. Pointing the vent down protects it from freezing rain or sleet.

111245-01B

www.desatech.com

17

Image 17
Contents CGEFP33PRB, CGEFP33NRB EFP33PRB, EFP33NRB Shown with optional Hearth base accessoryTable of Contents Safety Information Product Identification Fireplace Floor AssemblyUnpacking Product FeaturesLocal Codes Determining FRESH-AIR Flow for Fireplace Location AIR for Combustion VentilationProviding Adequate Ventilation Ventilation Air From Inside Building Ventilation AIRVentilation Air From Outdoors InstallationCheck GAS Type Installation Sequence Installation ClearancesRemoving Fireplace Screen and Floor Assembly Electrical HookupFor Mantel Installation Electrical Connections for Power CordRelocating Wall Switch Assembly For Recessed Fireplace For Recessed InstallationCutting Lines Mounting Wall Switch Assembly to Side of MantelMounting Blower to Firebox Installing Variable Speed Blower AccessoryLocation of Wiring Diagram Decal 3 from Blower Installing Switch and Cover Assembly and Speed Control Installing Thermostatic Blower AccessoryInstalling Bushings Operating the Blower Installing GAS Piping to Fireplace LocationInstallation Items Needed Propane/LP Connecting Fireplace to GAS SupplyNatural Test Pressures Equal To or Less Than 1/2 Psig 3.5 kPa Checking GAS ConnectionsTest Pressures In Excess Of 1/2 Psig 3.5 kPa Pressure Testing Fireplace GAS Connections Conventional Fireplace InstallationNailing Flanges BUILT-IN Fireplace InstallationRough Opening for Installing Wall Top Brass Trim Side Brass Trim Adjusting Set Screws Installing HoodInstalling Back Log #1 Cgefp Logs Shown Installing LogsInstalling Screen Installing Battery Into RemoteFor Your Safety Read Before Lighting Operating FireplaceControl Using Supplied Wall Switch AssemblyNormal Lighting Instructions To Turn OFF GAS To Appliance Manual Lighting Instructions for Electrical Power OutageShutting Off Heater Wireless Remote Control Optional Blower Operation Inspecting BurnersPilot Flame Pattern Main BurnerBurner Injector Holder Cleaning MaintenancePilot AIR Inlet Hole LogsObserved Problem Possible Cause Remedy TroubleshootingSee Cleaning and Mainte Statement above Gas leak. See WarningService Hints SpecificationsTechnical Service When Gas Pressure Is Too LowIllustrated Parts Breakdown Remote Control LOG Base Assembly Parts ListIllustrated Parts Breakdown KEY Part Number EFP33PRB EFP33NRB Description QTY Firebox Models CGEFP33PRB, CGEFP33NRB, EFP33PRB and EFP33NRB KEY Part Number Description QTY Accessories Replacement PartsHearth Base for USE with Cabinet Mantel Corner Mantel Accessory with Fireplace Perimeter TrimCorner Hearth Base for USE with Corner Mantel Wiring Diagram Templates This page Intentionally Left Blank Parts Central 111245-01B 111245-01B Not a UPC

EFP33NRB, CGEFP33PRB, CGEFP33NRB, EFP33PRB, EFP33NRB specifications

Desa offers a range of premium electric fireplaces with models such as EFP33NRB, CGEFP33PRB, CGEFP33NRB, EFP33PRB, and EFP33NRB, each designed to blend aesthetics with advanced heating technology. These electric fireplaces are renowned for their ability to create a warm ambiance without the hassle of traditional wood or gas fireplaces.

The EFP33NRB model, a part of Desa's electric fireplace collection, features a sleek design that fits seamlessly into various interior styles. With its realistic flame effect and adjustable brightness settings, users can customize their experience, enhancing any room while maintaining a cozy atmosphere. This model also incorporates energy-efficient LED technology, ensuring minimal power consumption without compromising on the visual appeal and comfort.

Similarly, the CGEFP33PRB and CGEFP33NRB are designed for those who appreciate the combination of style and functionality. These models offer a robust heating output, capable of warming larger spaces efficiently. The innovative heat management system also ensures even heat distribution, making these units suitable for year-round use. Additionally, remote control capabilities allow for effortless adjustment, enhancing user convenience.

The EFP33PRB features a modern framework that showcases the flames within a stylish casing. Its user-friendly interface includes touch controls and an easy-to-read display, allowing users to change settings with ease. The fireplace boasts a range of flame colors, allowing for personalization to match any decor or mood.

Across all these models, safety remains a top priority with built-in overheat protection and a tip-over switch, providing peace of mind during operation. Furthermore, the fireplaces operate quietly, ensuring an undisturbed environment while creating a warm, inviting space.

In conclusion, the Desa EFP33NRB, CGEFP33PRB, CGEFP33NRB, EFP33PRB, and EFP33NRB models represent the pinnacle of electric fireplace technology. With their modern designs, efficiency, and flexibility, they offer a perfect solution for anyone looking to enhance their living spaces with warmth and style. Whether for a contemporary home or a cozy cabin, these fireplaces promise to deliver both comfort and elegance.