Desa EFP33NRB installation manual Installing Logs, Installing Back Log #1 Cgefp Logs Shown

Page 24

INSTALLATION

Continued

INSTALLING LOGS

WARNING:Failuretoposition thepartsinaccordancewiththese diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.

CAUTION: Do not remove the warning and instruction labels attached to the heater base as- sembly. These markings contain important warranty information.

CAUTION: After installa- tion and periodically thereafter, check to ensure that no flame comes in contact with any log. With the heater set to HI, check to see if flames contact any log. If so, reposition logs according to the log installation instructions in this manual. Flames contact- ing logs will create soot.

It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.

1.Locate pegs on the bottom of back log (#1). Slide these pegs into the holes in the grate base behind the burner (see Figure 41).

2.Place the base of the middle log (#2) in the U-shaped slots of the grate base in front of the back log. The cutout on the right of the middle log should fit over the burner (see Figure 42). Make sure the front of the middle log is resting on the tabs of the grate base and the cutout area is centered over the burner “U” bend.

3.Locate the notches in the bottom of the front log (#3). Place the front log on the grate fingers. Make sure the notches of the front log line up with the grate fingers (see Figure 43).

4.Place left crossover log (#4) across logs #1, #2 and #3 fitting holes on bottom of log #4 onto pin on front and middle logs as shown in Figure 44.

5.Place right crossover log (#5) in the same manner on right side of logs (see Figure 44, page 25).

Back

Log (#3)

Hole in

Grate Base

Burner

Figure 41 - Installing Back Log (#1) [CGEFP Logs Shown]

Middle

Log (#3)

Cutout Tab

Burner

"U" Bend

U-shaped

Slot

Figure 42 - Installing Middle Log (#2) [CGEFP Logs Shown]

Front Log (#3)

Notches

Grate

Fingers

Figure 43 - Installing Front Log (#3)

[CGEFP Logs Shown]

24

www.desatech.com

111245-01B

Page 23 Page 25
Image 24
Page 23 Page 25
Contents Shown with optional Hearth base accessory CGEFP33PRB, CGEFP33NRB EFP33PRB, EFP33NRBTable of Contents Safety Information Fireplace Floor Assembly Product IdentificationProduct Features Local CodesUnpacking AIR for Combustion Ventilation Providing Adequate VentilationDetermining FRESH-AIR Flow for Fireplace Location Ventilation AIR Ventilation Air From Inside BuildingInstallation Check GAS TypeVentilation Air From Outdoors Installation Clearances Installation SequenceRemoving Fireplace Screen and Floor Assembly Electrical HookupElectrical Connections for Power Cord Relocating Wall Switch AssemblyFor Mantel Installation For Recessed Installation For Recessed FireplaceMounting Wall Switch Assembly to Side of Mantel Cutting LinesInstalling Variable Speed Blower Accessory Mounting Blower to FireboxLocation of Wiring Diagram Decal 3 from Blower Installing Thermostatic Blower Accessory Installing Switch and Cover Assembly and Speed ControlInstalling Bushings Installing GAS Piping to Fireplace Location Installation Items NeededOperating the Blower Connecting Fireplace to GAS Supply NaturalPropane/LP Checking GAS Connections Test Pressures In Excess Of 1/2 Psig 3.5 kPaTest Pressures Equal To or Less Than 1/2 Psig 3.5 kPa Conventional Fireplace Installation Pressure Testing Fireplace GAS ConnectionsBUILT-IN Fireplace Installation Nailing FlangesRough Opening for Installing Wall Installing Hood Top Brass Trim Side Brass Trim Adjusting Set ScrewsInstalling Logs Installing Back Log #1 Cgefp Logs ShownInstalling Battery Into Remote Installing ScreenFor Your Safety Read Before Lighting Operating FireplaceUsing Supplied Wall Switch Assembly Normal Lighting InstructionsControl Manual Lighting Instructions for Electrical Power Outage Shutting Off Heater Wireless Remote ControlTo Turn OFF GAS To Appliance Inspecting Burners Optional Blower OperationPilot Flame Pattern Main BurnerCleaning Maintenance Burner Injector HolderPilot AIR Inlet Hole LogsTroubleshooting Observed Problem Possible Cause RemedySee Cleaning and Mainte Gas leak. See Warning Statement aboveSpecifications Service HintsTechnical Service When Gas Pressure Is Too LowIllustrated Parts Breakdown Parts List Remote Control LOG Base AssemblyIllustrated Parts Breakdown KEY Part Number EFP33PRB EFP33NRB Description QTY Firebox Models CGEFP33PRB, CGEFP33NRB, EFP33PRB and EFP33NRB KEY Part Number Description QTY Replacement Parts AccessoriesCorner Mantel Accessory with Fireplace Perimeter Trim Corner Hearth Base for USE with Corner MantelHearth Base for USE with Cabinet Mantel Wiring Diagram Templates This page Intentionally Left Blank Parts Central 111245-01B 111245-01B Not a UPC

EFP33NRB, CGEFP33PRB, CGEFP33NRB, EFP33PRB, EFP33NRB specifications

Desa offers a range of premium electric fireplaces with models such as EFP33NRB, CGEFP33PRB, CGEFP33NRB, EFP33PRB, and EFP33NRB, each designed to blend aesthetics with advanced heating technology. These electric fireplaces are renowned for their ability to create a warm ambiance without the hassle of traditional wood or gas fireplaces.

The EFP33NRB model, a part of Desa's electric fireplace collection, features a sleek design that fits seamlessly into various interior styles. With its realistic flame effect and adjustable brightness settings, users can customize their experience, enhancing any room while maintaining a cozy atmosphere. This model also incorporates energy-efficient LED technology, ensuring minimal power consumption without compromising on the visual appeal and comfort.

Similarly, the CGEFP33PRB and CGEFP33NRB are designed for those who appreciate the combination of style and functionality. These models offer a robust heating output, capable of warming larger spaces efficiently. The innovative heat management system also ensures even heat distribution, making these units suitable for year-round use. Additionally, remote control capabilities allow for effortless adjustment, enhancing user convenience.

The EFP33PRB features a modern framework that showcases the flames within a stylish casing. Its user-friendly interface includes touch controls and an easy-to-read display, allowing users to change settings with ease. The fireplace boasts a range of flame colors, allowing for personalization to match any decor or mood.

Across all these models, safety remains a top priority with built-in overheat protection and a tip-over switch, providing peace of mind during operation. Furthermore, the fireplaces operate quietly, ensuring an undisturbed environment while creating a warm, inviting space.

In conclusion, the Desa EFP33NRB, CGEFP33PRB, CGEFP33NRB, EFP33PRB, and EFP33NRB models represent the pinnacle of electric fireplace technology. With their modern designs, efficiency, and flexibility, they offer a perfect solution for anyone looking to enhance their living spaces with warmth and style. Whether for a contemporary home or a cozy cabin, these fireplaces promise to deliver both comfort and elegance.
Top Page Image Contents