Desa CGEFP33PRB, CGEFP33NRB, EFP33PRB, EFP33NRB installation manual Installing Hood

Page 23
Framing Material

INSTALLATION

Continued

Top Brass Trim

Side Brass

Trim Adjusting Set Screws

Wall board or facing material (above firebox) may be of combustible material, including decorative mantel ornaments or other similar projec- tions off of the facing material.

Firebox

Mantel Shelf

10"

8"

6"

2 1/2"

Noncombustible

 

 

Material May

 

 

Project Off this

 

 

Surface above

 

 

the Firebox

13"

16"

Hood

 

 

19"

21"

Plate

Slot

Shim

Mitered Edge

Slot

Wire-mesh Screen

 

Note: All vertical

Supplied

measurements are

from top of fireplace

Firebox

hood opening to

Hood

bottom of mantel

Must Be

shelf. These minimum

Used at

clearances replace any

All Times

other recommended

 

clearances supplied

 

with your ANSI Z21.11.2

 

approved gas logs.

Figure 38 - Assembling Brass Trim

Trim

Hanging

Screws

Hanging

Notches

Figure 37 - Minimum Mantel Clearances

for Built-In Installation

ASSEMBLING AND ATTACHING OPTIONAL BRASS TRIM (Included with Mantel Accessory)

Note: The instructions below show assembling and attaching brass trim to fireplace.

1.Remove packaging from three pieces of brass trim.

2.Locate four brass screws, two adjusting plates with set screws and two shims in the hardware packet.

3.Align shim under adjusting plate as shown in Figure 38.

4.Slide one end of adjusting plate/shim in slot on mitered edge of top brass trim (see Figure 38).

5.Slide other end of adjusting plate/shim in slot on mitered edge of side brass trim (see Figure 38).

6.While firmly holding edges of brass trim to- gether, tighten both set screws on the adjusting plate with slotted screwdriver.

7.Repeat steps 1 through 6 for the other side.

8.Tighten trim hanging screws (#10 x 6.25 shoulder) into holes in cabinets. Place the assembled trim onto fireplace cabinet. Align hanging notches on trim with hanging screws on side of fireplace (see Figure 39). Push trim firmly into place, sliding hanging notches over hanging screws.

on Trim

Assembled

Brass Trim

Figure 39 - Attaching Brass Trim to Fireplace

INSTALLING HOOD

Install hood to top of firebox as shown in Figure 40. Use 3 Phillips screws provided.

Figure 40 - Installing Hood to Firebox

111245-01B

www.desatech.com

23

Page 22 Page 24
Image 23
Page 22 Page 24
Contents CGEFP33PRB, CGEFP33NRB EFP33PRB, EFP33NRB Shown with optional Hearth base accessoryTable of Contents Safety Information Product Identification Fireplace Floor AssemblyUnpacking Product FeaturesLocal Codes Determining FRESH-AIR Flow for Fireplace Location AIR for Combustion VentilationProviding Adequate Ventilation Ventilation Air From Inside Building Ventilation AIRVentilation Air From Outdoors InstallationCheck GAS Type Electrical Hookup Installation ClearancesInstallation Sequence Removing Fireplace Screen and Floor AssemblyFor Mantel Installation Electrical Connections for Power CordRelocating Wall Switch Assembly For Recessed Fireplace For Recessed InstallationCutting Lines Mounting Wall Switch Assembly to Side of MantelMounting Blower to Firebox Installing Variable Speed Blower AccessoryLocation of Wiring Diagram Decal 3 from Blower Installing Switch and Cover Assembly and Speed Control Installing Thermostatic Blower AccessoryInstalling Bushings Operating the Blower Installing GAS Piping to Fireplace LocationInstallation Items Needed Propane/LP Connecting Fireplace to GAS SupplyNatural Test Pressures Equal To or Less Than 1/2 Psig 3.5 kPa Checking GAS ConnectionsTest Pressures In Excess Of 1/2 Psig 3.5 kPa Pressure Testing Fireplace GAS Connections Conventional Fireplace InstallationNailing Flanges BUILT-IN Fireplace InstallationRough Opening for Installing Wall Top Brass Trim Side Brass Trim Adjusting Set Screws Installing HoodInstalling Back Log #1 Cgefp Logs Shown Installing LogsOperating Fireplace Installing Battery Into RemoteInstalling Screen For Your Safety Read Before LightingControl Using Supplied Wall Switch AssemblyNormal Lighting Instructions To Turn OFF GAS To Appliance Manual Lighting Instructions for Electrical Power OutageShutting Off Heater Wireless Remote Control Main Burner Inspecting BurnersOptional Blower Operation Pilot Flame PatternLogs Cleaning MaintenanceBurner Injector Holder Pilot AIR Inlet HoleObserved Problem Possible Cause Remedy TroubleshootingSee Cleaning and Mainte Statement above Gas leak. See WarningWhen Gas Pressure Is Too Low SpecificationsService Hints Technical ServiceIllustrated Parts Breakdown Remote Control LOG Base Assembly Parts ListIllustrated Parts Breakdown KEY Part Number EFP33PRB EFP33NRB Description QTY Firebox Models CGEFP33PRB, CGEFP33NRB, EFP33PRB and EFP33NRB KEY Part Number Description QTY Accessories Replacement PartsHearth Base for USE with Cabinet Mantel Corner Mantel Accessory with Fireplace Perimeter TrimCorner Hearth Base for USE with Corner Mantel Wiring Diagram Templates This page Intentionally Left Blank Parts Central 111245-01B 111245-01B Not a UPC

EFP33NRB, CGEFP33PRB, CGEFP33NRB, EFP33PRB, EFP33NRB specifications

Desa offers a range of premium electric fireplaces with models such as EFP33NRB, CGEFP33PRB, CGEFP33NRB, EFP33PRB, and EFP33NRB, each designed to blend aesthetics with advanced heating technology. These electric fireplaces are renowned for their ability to create a warm ambiance without the hassle of traditional wood or gas fireplaces.

The EFP33NRB model, a part of Desa's electric fireplace collection, features a sleek design that fits seamlessly into various interior styles. With its realistic flame effect and adjustable brightness settings, users can customize their experience, enhancing any room while maintaining a cozy atmosphere. This model also incorporates energy-efficient LED technology, ensuring minimal power consumption without compromising on the visual appeal and comfort.

Similarly, the CGEFP33PRB and CGEFP33NRB are designed for those who appreciate the combination of style and functionality. These models offer a robust heating output, capable of warming larger spaces efficiently. The innovative heat management system also ensures even heat distribution, making these units suitable for year-round use. Additionally, remote control capabilities allow for effortless adjustment, enhancing user convenience.

The EFP33PRB features a modern framework that showcases the flames within a stylish casing. Its user-friendly interface includes touch controls and an easy-to-read display, allowing users to change settings with ease. The fireplace boasts a range of flame colors, allowing for personalization to match any decor or mood.

Across all these models, safety remains a top priority with built-in overheat protection and a tip-over switch, providing peace of mind during operation. Furthermore, the fireplaces operate quietly, ensuring an undisturbed environment while creating a warm, inviting space.

In conclusion, the Desa EFP33NRB, CGEFP33PRB, CGEFP33NRB, EFP33PRB, and EFP33NRB models represent the pinnacle of electric fireplace technology. With their modern designs, efficiency, and flexibility, they offer a perfect solution for anyone looking to enhance their living spaces with warmth and style. Whether for a contemporary home or a cozy cabin, these fireplaces promise to deliver both comfort and elegance.
Top Page Image Contents