Desa EFP33NRB installation manual Mounting Wall Switch Assembly to Side of Mantel, Cutting Lines

Page 12

INSTALLATION

Continued

8.Remove paper template from wall.

9.Drill 3/8" holes at each mark.

10.Using a straight edge and pencil, connect the outer edges of the 4 holes for the rectangle (see Figure 10). This will give you cutting lines for the rectangle you will cut in the wall.

11.Using a keyhole saw, hack saw blade, drill, file or other suitable tool, carefully cut out the rectangular opening. Note: The corners of the rectangle may be round. IMPORTANT: Do not exceed the size of the rectangle on template.

12.From inside the recessed opening for the fireplace, carefully pass wall switch assembly through the rectangular opening to the outside of the wall.

13.Using wall anchors supplied in hardware pack- age, fold wall anchor as shown in Figure 11.

14.Insert wall anchor, wings first, into hole. Tap anchor flush to wall.

15.For thin walls (1/2" or less), insert red key into wall anchor. Push red key to “pop” open anchor wings. See Figure 12. IMPORTANT: Do not hammer key! For thick walls (over 1/2" thick), do not pop open wings.

16.Position wall switch assembly vertically over wall openings with decal lettering upright (see Figure 13).

17.Insert mounting screws, removed in step 2 of Relocating Wall Switch Assembly on page 10, through holes in wall plate and into wall anchors.

18.Tighten screws until wall plate is firmly at- tached to wall. Do not overtighten.

Opening in Wall or Mantel Wall

Wall Switch

Assembly

Screws

Figure 13 - Securing Wall Switch

Assembly

Mounting Wall Switch Assembly to Side of Mantel

7.

Create three openings in the mantel wall ac-

 

cording to Template 2, page 41. This is best

 

done by making a pattern to work with on the

Make

Marks at

Centers

of Holes

Template from This Manual

43/4"

3 3/4"

3/8"

3/8" Diameter 2 Holes

3/4"

3/16"

Cutting Lines

 

mantel. Carefully cut page 39/40 from manual

 

and tape paper template vertically onto mantel

 

wall at preferred location. Pierce the paper at

 

the centers of the 2 holes with a nail or sharp

 

pencil, leaving a mark on the wall. Do the

 

same at centers of the four circles near the

 

corners of the rectangle.

8.

Remove paper template from mantel wall.

9.

Drill 1/8" pilot holes at each mark for top and

 

bottom screw holes. Drill 3/8" holes at each

 

mark for centers of four circles near corners

 

of rectangle.

10.

Using a straight edge and pencil, connect the

 

outer edges of the 4 holes for the rectangle (see

 

Figure 10). This will give you cutting lines for

Tape

Figure 10 - Using Template for Wall Switch Assembly Installation

Figure 11 - Folding

Figure 12 - Popping

Anchor

Open Anchor Wings

 

for Thin Walls

the rectangle you will cut in the mantel wall.

11. Using a keyhole saw, hack saw blade, drill,

file or other suitable tool, carefully cut out the

rectangular opening. Note: The corners of the

rectangle may be round. IMPORTANT: Do not

exceed the size of the rectangle on template.

12. Carefully pass wall switch assembly through

rectangular opening from inside mantel (see

Figure 13).

12

www.desatech.com

111245-01B

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Shown with optional Hearth base accessory CGEFP33PRB, CGEFP33NRB EFP33PRB, EFP33NRBTable of Contents Safety Information Fireplace Floor Assembly Product IdentificationProduct Features Local CodesUnpacking AIR for Combustion Ventilation Providing Adequate VentilationDetermining FRESH-AIR Flow for Fireplace Location Ventilation AIR Ventilation Air From Inside BuildingInstallation Check GAS TypeVentilation Air From Outdoors Installation Clearances Installation SequenceRemoving Fireplace Screen and Floor Assembly Electrical HookupElectrical Connections for Power Cord Relocating Wall Switch AssemblyFor Mantel Installation For Recessed Installation For Recessed FireplaceMounting Wall Switch Assembly to Side of Mantel Cutting LinesInstalling Variable Speed Blower Accessory Mounting Blower to FireboxLocation of Wiring Diagram Decal 3 from Blower Installing Thermostatic Blower Accessory Installing Switch and Cover Assembly and Speed ControlInstalling Bushings Installing GAS Piping to Fireplace Location Installation Items NeededOperating the Blower Connecting Fireplace to GAS Supply NaturalPropane/LP Checking GAS Connections Test Pressures In Excess Of 1/2 Psig 3.5 kPaTest Pressures Equal To or Less Than 1/2 Psig 3.5 kPa Conventional Fireplace Installation Pressure Testing Fireplace GAS ConnectionsBUILT-IN Fireplace Installation Nailing FlangesRough Opening for Installing Wall Installing Hood Top Brass Trim Side Brass Trim Adjusting Set ScrewsInstalling Logs Installing Back Log #1 Cgefp Logs ShownInstalling Battery Into Remote Installing ScreenFor Your Safety Read Before Lighting Operating FireplaceUsing Supplied Wall Switch Assembly Normal Lighting InstructionsControl Manual Lighting Instructions for Electrical Power Outage Shutting Off Heater Wireless Remote ControlTo Turn OFF GAS To Appliance Inspecting Burners Optional Blower OperationPilot Flame Pattern Main BurnerCleaning Maintenance Burner Injector HolderPilot AIR Inlet Hole LogsTroubleshooting Observed Problem Possible Cause RemedySee Cleaning and Mainte Gas leak. See Warning Statement aboveSpecifications Service HintsTechnical Service When Gas Pressure Is Too LowIllustrated Parts Breakdown Parts List Remote Control LOG Base AssemblyIllustrated Parts Breakdown KEY Part Number EFP33PRB EFP33NRB Description QTY Firebox Models CGEFP33PRB, CGEFP33NRB, EFP33PRB and EFP33NRB KEY Part Number Description QTY Replacement Parts AccessoriesCorner Mantel Accessory with Fireplace Perimeter Trim Corner Hearth Base for USE with Corner MantelHearth Base for USE with Cabinet Mantel Wiring Diagram Templates This page Intentionally Left Blank Parts Central 111245-01B 111245-01B Not a UPC

EFP33NRB, CGEFP33PRB, CGEFP33NRB, EFP33PRB, EFP33NRB specifications

Desa offers a range of premium electric fireplaces with models such as EFP33NRB, CGEFP33PRB, CGEFP33NRB, EFP33PRB, and EFP33NRB, each designed to blend aesthetics with advanced heating technology. These electric fireplaces are renowned for their ability to create a warm ambiance without the hassle of traditional wood or gas fireplaces.

The EFP33NRB model, a part of Desa's electric fireplace collection, features a sleek design that fits seamlessly into various interior styles. With its realistic flame effect and adjustable brightness settings, users can customize their experience, enhancing any room while maintaining a cozy atmosphere. This model also incorporates energy-efficient LED technology, ensuring minimal power consumption without compromising on the visual appeal and comfort.

Similarly, the CGEFP33PRB and CGEFP33NRB are designed for those who appreciate the combination of style and functionality. These models offer a robust heating output, capable of warming larger spaces efficiently. The innovative heat management system also ensures even heat distribution, making these units suitable for year-round use. Additionally, remote control capabilities allow for effortless adjustment, enhancing user convenience.

The EFP33PRB features a modern framework that showcases the flames within a stylish casing. Its user-friendly interface includes touch controls and an easy-to-read display, allowing users to change settings with ease. The fireplace boasts a range of flame colors, allowing for personalization to match any decor or mood.

Across all these models, safety remains a top priority with built-in overheat protection and a tip-over switch, providing peace of mind during operation. Furthermore, the fireplaces operate quietly, ensuring an undisturbed environment while creating a warm, inviting space.

In conclusion, the Desa EFP33NRB, CGEFP33PRB, CGEFP33NRB, EFP33PRB, and EFP33NRB models represent the pinnacle of electric fireplace technology. With their modern designs, efficiency, and flexibility, they offer a perfect solution for anyone looking to enhance their living spaces with warmth and style. Whether for a contemporary home or a cozy cabin, these fireplaces promise to deliver both comfort and elegance.
Top Page Image Contents