Desa (V)T36EPA SERIES, (V)T36ENA SERIES Wiring Diagram, Fireplace Installation, Continued

24	FIREPLACE INSTALLATION
	Wall Switch Installation
	Optional Remote Control Installation (Model WRC)
	WIRING DIAGRAM

FIREPLACE INSTALLATION

Continued

WALL SWITCH INSTALLATION

The installation of a wall switch allows you to activate the gas control valve and turn the fireplace on and off. The wall switch is to be connected to the incoming 120 volt regular household wiring that supplies the electricity to the fireplace. Refer to wiring diagram below.

OPTIONAL REMOTE CONTROL

INSTALLATION (Model WRC)

Note: If using optional wireless hand-held remote control, the wall switch must be in the ON position to be operational. The remote control then becomes the switching mechanism for fireplace operation.

1.Open lower louver panel of firebox.

2.The WRC model receiver does not require a battery. The re- ceiver can be installed by first plugging the short extension cord into the fireplace receptacle. Then plug the receiver unit into the extension cord. Finally plug the ignition module plug into the receiver unit (see Figure 46).

3.Activate the remote handset battery by removing the insulat- ing tab on the back of the handset (see Figure 47). The battery is included pre-installed.

4.Once the battery is activated the unit is ready to use.

5.Close lower louver panel.

Fireplace

Receptacle

Remote Control

Receiver

Extension Cord	Ignition
	Module Plug

Figure 46 - Installing the WRC Remote Receiver

Battery Cover

12 Volt Battery

Back of	Pull to Remove
Handset
	Insulation Tab

Figure 47 - Installing Battery into Back of Handset

WIRING DIAGRAM

Pilot Burner

INCOMING MAIN
GAS SUPPLY	Pilot Gas
	Line
	MV
	TH
EV1	PV/MV
	TR
	GND
	PV
	IGN

EV2

24V AC

STEP DOWN

TRANSFORMER

120V AC

GAS LINE TO

BURNER

WALL SWITCH

(NOT SUPPLIED)

ON OFF

BLACK	INCOMING
WHITE	120V AC
GREEN	(FUSE BOX
	OR BREAKER)

BLACK WHITE GREEN

ELECTRICAL RATING:

120v, 60Hz, 0.7A

OPTIONAL

REMOTE

CONTROL

For..com

111251-01D