OWNER’S MANUAL
FIREPLACE INSTALLATION
Continued
Fireplace Models HDV37N/P and HDV41N/P
1.Place log#1 (back log) on grate. Make sure the lower middle section of the log fits securely into the open area in back of grate (see Figure 53).
2.Place log #2 (two log assembly) onto pins on left front and middle section of the front burner (see Figure 54).
3.Place log #3 (crossover assembly) onto the front right pin on front burner with the crossover log resting in notch on back log (see Figure 55).
4.Place lava rock along sides and front of firebox bottom.
NOTICE: Do not put lava rock on burner or under burner. Placing lava rock on burner could cause performance problems.
It is not necessary to use all of the lava rock provided.
5.Pull ember material apart into pieces no larger than a dime. Place these pieces loosely onto the exposed section of the front burner and space between logs 2 and 3 where front burner is exposed (see Figure 56). This will create the glowing appearance as the flame touches the em- ber material. Do not block ports by us- ing too much ember material in one area. It is not necessary to use all of the em- ber material provided.
7.Replace the glass door. See Removing/ Replacing Glass Door, page 22.
WARNING: The glass door must be securely in place before running this fireplace. Do not run this fireplace if glass is missing or broken.
1
3
Figure 53 - Installing Log No. 1
2
Figure 55- Installing Log Assembly No. 3
Ember Material
Figure 54 - Installing Log Assembly No. 2
Figure 56 - Placing Ember Material on
Burner
104558 | 25 |