® (B)HDV37N/P AND (B)HDV41N/P
DIRECT-VENT FIREPLACE (NATURAL/PROPANE/LP)
FIREPLACE INSTALLATION
Continued
REMOVING/REPLACING GLASS DOOR
You must remove glass door to install op- tional brick liners, logs, lava rock, and em- ber material.
CAUTION: Do not operate this fireplace with a broken glass door panel or without the glass door panel securely in place. For re- placement part information see Replacement Parts, page 33.
1.Remove the upper louver panel by lift- ing upward and out (see Figure 44).
2.Remove the screws from the three tabs at the top of the glass door while hold- ing door securely keeping it from fall- ing forward.
3.Grasp door by both sides and ease it upward off of the lower bracket (see Figure 45).
4.To replace glass door, follow the above instructions in reverse.
Top Louver
Panel
Screw
Glass Door
Assembly
Lower Bracket for
Glass Door Assembly
Figure 45 -Removing/ReplacingGlassDoor
Attaching Magnetic Decorative Brass Strips - HDV Only
The HDV fireplaces come with a set of two magnetic decorative brass strips. Before at- taching strips to fireplace, remove plastic film from brass pieces. After installing door, attach these strips to the top and bottom of glass door frame.
Figure 44 - Removing Top Louver Panel
22 | 104558 |