Desa CD36TN-M installation manual Continued, Electrical Supply Connection, Number, Description

Venting Installation

instructions

	Continued
Number	Description
CVVK-58	Ceiling Vertical Vent Kit
	(Includes: 30° Offset Return, 7"-12"
	Adjustable Pipe, Flue Restrictor,
	Vertical High Wind Termination,
	3' Pipe, 4' Pipe, Firestop Plate,
	Firestop Thimble, Storm Collar,
	Roof Flashing [0/12 - 6/12], 38
	Screws)
CHVK-58	Corner Horizontal Vent Kit,
	(Includes 90° Elbow, 7"-12"
	Adjustable Pipe, Wall Firestop,
	Horizontal Square Termination,
	6" Pipe, 18 Screws)
HHTK-58	High Wind Round Horizontal
	Termination Kit (Includes Round
	Termination, Wall Firestop, 45°
	Elbow)
HHT-58	High Wind Round Horizontal
	Termination Kit, Galv.
HTS-58	Horizontal Square Termination,
	Galv. HTKS-58 Horizontal Square
	Termination Kit (Includes: Square
	Termination, Wall Firestop, 45°
	Elbow)
VT-58	Vertical Round Termination, Galv.
SC-58	Storm Collar, Galv.
WF-58	Wall Firestop, Galv.
RF-58-6	Roof Flashing - 0 to 6/12 Pitch,
	Galv.
RF-58-12	Roof Flashing - 6/12 to 12/12
	Pitch, Galv.
VR-58	Vertical Restrictor, Galv.
S-58	Vinyl Siding Standoff, Galv.
WS-58	Wall Strap
CS-58	Cathedral Ceiling Support
FP-58	Firestop Plate
SF-58	Stucco Flashing -
	For use with HTS-58
RF-58	Flat Roof Flashing

Fireplace

Installation

ELECTRICAL SUPPLY CONNECTION

CAUTION: Disconnect the electrical power to the supply circuit before attempting to con- nect or service this appliance.

WARNING: This appliance, when installed must be electri- cally grounded in accordance with local code or in the ab- sence of local code, with the current National Electric Code, ANSI/NFPA 70, or the Canadian Electric Code, CSA C22.1.

A prewired junction box receptacle with strain relief is provided on the right side of the cabinet for hard wiring the unit to a 15 Amp, 120VAC, 60Hz grounded branch circuit. If the installation demands that the electrical supply be connected from the left side, the entire receptacle box can be relocated to the left side by following these instructions:

Note: If you do not need to relocate the junction box, to connect the electric supply follow steps 8 through 11 only:

1.Remove 2 screws and outer cover with strain relief bushing on right side of cabinet (see Figure 26).

2.Remove inner retaining screw on junction box mounting tab.

3.Slide junction box up until screw mounting tab is lined up to notch in outer cabinet.

J-Box Cover	J-Box
with Strain	Cover
Relief	J-Box Cover with
	Strain Relief

Romex Cable

J-Box with

Receptacle

Screw/Tab Retainer

Figure 26 - Relocating Junction Box

Receptacle and Electrical Supply

Connection

18 www.desatech.com 118531-01A