Operating Fireplace
for your safety
Read before lighting
WARNING: If you do not fol- low these instructions exactly, a fire or explosion may result causing property damage, per- sonal injury or loss of life.
A. This appliance has a pilot which must be |
lighted by hand. When lighting the pilot, |
follow these instructions exactly. |
B. BEFORE LIGHTING smell all around the |
appliance area for gas. Be sure to smell next |
to the floor because some gas is heavier than |
air and will settle on the floor. |
WHAT TO DO IF YOU SMELL GAS |
• Do not try to light any appliance. |
• Do not touch any electric switch; do not |
use any phone in your building. |
• Immediately call your gas supplier |
6.The pilot is located by the main burner and should not require accessing for lighting.
7.Turn gas control knob counterclockwise to
PILOT.
8.Push in gas control knob all the way and hold. Immediately light the pilot by repeatedly de- pressing the piezo spark ignitor until a flame appears. Continue to hold for about 1 minute after the pilot is lit. Release gas control knob and it will pop back. Pilot should remain lit. If it goes out, repeat steps 5 through 8.
•If gas control knob does not pop up when released, stop and immediately call your service technician or gas supplier.
•If the pilot will not stay lit after several tries, turn the gas control knob to OFF and call your service technician or gas supplier.
9.Turn on all electric power to fireplace.
10.Turn gas control knob counterclockwise to “ON”.
11.This valve is equipped with a HI/LO fea- ture. Set fireplace input as desired.
12.Close lower louver panel.
from a neighbor's phone. Follow the gas |
supplier's instructions. |
C. Use only your hand to push in or turn the |
gas control knob. Never use tools. If the knob |
will not push in or turn by hand, don't try to |
repair it, call a qualified service technician. |
Force or attempted repair may result in a |
fire or explosion. |
D. Do not use this appliance if any part has |
Gas Control Variable | |
Knob | Control Knob |
| OT |
| IL |
| P |
| IL |
P OT | |
F | HI |
F | O |
O | |
| N |
| LO |
IN | OUT |
Piezo Ignitor
TPTH TP TH
been under water. Immediately call a |
qualified service technician to inspect the |
appliance and to replace any part of the |
control system and any gas control which |
has been under water. |
lighting
instructions
1.STOP! Read the safety information above.
2.Open lower louver panel.
3.Turn off all electric power to the fire- place.
4.Push in gas control knob slightly and turn clockwise to OFF (see Figure 48).
5.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow “B” in the safety information above. If you don’t smell gas go to the next step.
Figure 48 - Control Valve
TO TURN OFF GAS
TO APPLIANCE
1.Open lower louver panel.
2.Set the wall switch to the OFF position or the HRC selector switch (when equipped) to prevent draining the battery.
3.Turn off all electric power to the appliance if service is to be performed.
4.Push in gas control knob slightly and turn clockwise to OFF.
5.Close lower louver panel.
Shutting Off Burners Only (pilot stays lit) You may shut off the burners and keep the pilot lit by doing one of the following:
1.Turn gas control knob clockwise to the PILOT position.
2.Set the wall switch to the OFF position or the HRC selector switch (when equipped) to prevent draining the battery.
28 | www.desatech.com |