Continued, Manual Lighting Procedure, Manual Mode

Operating fireplace

Continued

MANUAL LIGHTING

PROCEDURE

1.Remove glass door (see Removing/Replacing Glass Door, page 25).

2.Follow steps 1 through 8 under Lighting In- structions, page 28.

3.Depress gas control knob and light pilot with match.

4.Keep gas control knob pressed in for 30 seconds after lighting pilot. After 30 sec- onds, release gas control knob. Follow steps 9 through 12 under Lighting Instructions, page 28.

5.Replace glass door (see Removing/Replacing Glass Door, page 25).

IMPORTANT: Do not leave the selector switch in the REMOTE or ON position when the pilot is not lit. This will drain the battery.

On/Off Series Model HRC100

Hold the control button on the hand-held remote until burner turns on. Hold the con- trol button again until burner turns off (see Figure 50).

To Lock press both buttons on hand-held remote control until light stops flashing. Hand- held remote control is now locked. If the fire is on it will be turned off automatically. In the locked state, the light will not light up when any button is pressed.

To Unlock press both buttons together on hand-held remote control until the light stops flashing. The hand-held remote is now unlocked.

optional Hand-Held

REMOTE OPERATION

Note: All remote control accessories must be purchased separately (see Accessories, page 39). Follow instructions included with the remote control.

NOTICE: You must light the pilot before using the hand-held re- mote control unit. See Lighting Instructions, page 28.

After lighting, let pilot flame burn for about one minute. Turn control knob to ON posi- tion. Adjust flame adjustment knob anywhere between HI and LO. Slide the selector switch to the REMOTE position (see Figure 49). Note: The burner may light if hand-held remote was on when selector switch was last turned off. You can now turn the burner on and off with the hand-held remote control unit.

Blower Control Knob
(Optional Accessory)	Variable Control
	Variable Control
	Knob
OFF ON
	N
	O	L
		L
	T	O	I
ON OFF REMOTE	O	O	H
ON OFF REMOTE	L	O
	I	F
	P F

Gas Control Knob

Selector Switch in in ON Position

Remote Position

Figure 49 - Setting the Selector Switch,

Gas Control Knob and Variable Control

Knob for Remote Operation

Indicator
Light	Control
	Button

Figure 50 - On/Off Hand-Held Remote

Control Unit HRC100

Thermostat Series Model HRC200

The hand-held remote can be operated using ei- ther the manual mode (MANU) or thermostatic mode (AUTO) (see Figure 51, page 30). To select Fahrenheit/Centigrade mode display, carefully press the ˚C/˚F mode button with the end of a paper clip or similar blunt object.

Manual Mode

1. Press the POWER and LOCK buttons together to turn on the hand-held remote control.

2. Press the MANU button to turn on the fireplace.

3. Press the POWER and LOCK buttons together to turn off the fireplace.

Auto (Thermostatic) Mode

1. Press the POWER and LOCK buttons together to turn on the hand-held remote control.

2. Press AUTO button to select this mode.

3. Set the desired room temperature by pressing the TEMP + or - buttons.

118531-01A