Vermont Castings UVS27
Operation
Your First Fire
Read these instructions carefully and familiarize yourself with the burner controls shown on Page 18. Locate the pilot assembly, Figure 28. Follow the lighting instructions on Page 17 exactly.
During the first fire, it is not unusual to smell some odor associated with new logs, paint and metal being heated. Odors should dissipate within the first eight to ten hours, however, you can open a window to provide fresh air to alleviate the condition.
Pilot and Burner Inspection
Each time you light your heater check that the pilot flame and burner flame patterns are as shown in Figures 31 and 32. If flame patterns are incorrect, turn the heater off. Contact your dealer or a qualified gas technician for assistance. Do not operate the heater until the pilot flame is correct.
Follow regular maintenance procedures as described on Page 20.
Natural
Pilot
LP Pilot
ST673
Fig. 28 Pilot assembly location.
Flame & Temperature Adjustment
RN/RP Models
For units equipped with ‘HI/LO’ valves the flame adjustment is accomplished by rotating the ‘HI/LO’ adjustment knob located near the center of the gas control valve. (Fig. 29, 30)
16
Turn |
|
|
|
counterclockwise | LO | HI | Turn clockwise |
to decrease |
| to increase | |
|
| ||
flame height |
|
| flame height |
|
|
| HV102 |
|
|
|
|
Fig. 29 Flame adjustment knob for Honeywell Valve.
SIT 630
Turn
counterclockwise |
| HI | Turn clockwise | |
|
| |||
| OFF | to decrease | ||
to increase |
| |||
LO | PILOT | |||
flame height | ||||
flame height | ||||
|
| |||
|
|
| ||
|
|
| HV117 |
Fig. 30 Flame adjustment knob for Eurosit Valve.
Flame Characteristics
It is important to periodically perform a visual check of the pilot and burner flames. Compare them to the pictorial illustrated below. (Fig. 31, 32) If the flame patterns appear abnormal contact a qualified service provider for service and adjustment.
| ST198 |
Fig. 31 | Correct pilot flame appearance. |
| LG225 |
Fig. 32 | Correct burner flame pattern. |
| 20005004 |