Vermont Casting D232 installation instructions Options, FAN KIT - FK24, Remote Control

OPTIONS

FAN KIT - FK24

It will be easier to install the fan before connecting the gas line to the fireplace.

1.Open front access door panel by pulling forward on brass lip.

2.Install the fan through the opening at the back of the pedestal, with the outlet pointed up and the fan mounting bracket facing the back of the fireplace (Fig. 44). . The fan mounts over two studs which hold the fan just below the firebox floor. Hold the fan in place with the two nuts provided.

3.Locate the fan speed control/junction box on screw studs provided on base of the fireplace. Tighten with nuts.

4.Install thermal sensor element on screw studs located to the right of the gas valve on the burner base.

5.Plug in grounded service cord to a convenient wall receptacle.

This fan assembly comes completely wired to eliminate the need for electricians. This electrical device, when installed, must be electrically connected and grounded in accordance with local codes. In the absence of local codes, with the current CSA C22.1 CANADIAN ELECTRICAL CODE.

For U.S.A. installation: Follow local codes and the NATIONAL ELECTRICAL CODE ANSI/ NFPA No.70-1984.

A: SPEED CONTROL

B: TEMPERATURE SENSOR

C: FAN

C

B

A

Black

White

Ground

Fig. 43

Stud

		Fan is
Thermal sensor
		installed at
location
		the back
	Valve	of the
		pedestal

Fan speed TOP VIEW
control/
Junction
box	Fig. 44

Should this fan require servicing, the power supply must be disconnected. For rewiring of any replacement components see Fig. 43.

REMOTE CONTROL

Only for units with RN/RP valve.

MRC1 - On/Off Button Remote Control

MRC2 - Temperature Control Remote

MRC3 - Temperature Control w/digital display &

24 hour programmable clock

IMT - Wall Mounted Thermostat

- 26 -