Blomus 65330 owner manual Assembly and mounting, Operating the fireplace

12 Í Owner’s manual/Installation instructions

5. Assembly and mounting

5.1Choosing the best place and surface to install the fireplace.

Please check if the designated room and surface is suit- able to operate the fireplace as follows:

•The room must have the minimum airspace volume as detailed in paragraph 3.

•Check if the room has adequate ventilation openings and consider the required air changes as detailed in pa- ragraph 3.

•Position the fireplace on a suitable surface ensuring that a minimum safety distance of 1 m (3.3 ft) from any flammable material can always be maintained. Consider also that curtains and drapes may wave when a window is opened.

•65333 ONLY: This unit with 4 glass screens can be used with caution on a protected patio away from direct sunlight. Use in mild weather with only a slight breeze.

•Is the designated surface heat resistant? Synthetic flooring, wood, laminate, carpet, PVC, fabric or other non heat resistant surfaces may not be suitable.

•The surface must be level.

•A table must be of sturdy construction and stand squarely on the floor without any tendency to shake or wobble. The fireplace should stand within the perimeter of a table – it should not overlap the edge of the table.

•Is the surface strong enough? The filled fireplace weights up to 20 kg (44 lb).

•Make sure that the surface including the fireplace can- not be knocked over. If positioned on the floor make sure the fireplace is not within the main walkways (risk of stumbling).

5.2 Assembling the fireplace

VIDRO fireplace units: 65330, 65331 and 65333 DANGER! Risk of injuries!

Please be careful when mounting the glass.

1.Place the safety basin into the designated opening in the fireplace body.

2.Place the burner into the safety basin. Please make sure it is arranged the right way (see image).

3.Mount the flame regula- tor with the brushed side fa- cing up on the slide rails located at each end of the burner.

4. Fit the burner cover onto the opening. Make sure the brushed side faces up.

5. Check that the lever ope- rates the flame regulator so it slides smoothly, and opens and closes completely.

6. Carefully fit the two glass sections into the two slots provided. Make sure the rounded edges face up.

7.Unit 65333: Carefully fit the four glass sections into the four slots provided. Make sure the rounded edges face up.

8.Assembly is complete if the burner cover fits tightly

into the opening and the opening and closing mechanism works smoothly and completely.

6. Operating the fireplace

WARNING! Risk of suffocation!

Make sure there is sufficient ventilation while the pro- duct is in use (open windows). Refer to paragraph 3. If you exper-ience sudden fatigue and lack of concentra- tion, it may indicate a possible lack of oxygen.

6.1Filling the fireplace with bio-ethanol WARNINGS! Risk of fires and burns!

Only use bio-ethanol. Refer to paragraph 1.1

In the very early and very late stages of burning the flame may be of a blue colour, making the flame not well visible. Always make sure that the flame is really shut off and the burner has cooled down for at least 15 minutes before touching, filling or refilling the burner.

•Never pour ethanol into a flame or into the hot burner.

•Do not smoke, eat or drink when handling ethanol.

•Spilled ethanol must immediately be removed from any surface to avoid ignition of the spilled liquid. Clean the spot with water.

•Ethanol can leave marks on some surfaces such as wood or paint. Please be careful not to spill ethanol.

Fill fireplace with bio-ethanol

VIDRO fireplace units: 65330, 65331 and 65333

	Unit No.		Capacities of the burners
65330			max. 1 litre (33.8 fl.oz)
	65331		max. 2 litre (67.62 fl.oz)
		65333	max. 2 litre (67.62 fl.oz)