OPERATING INSTRUCTIONS
FITTING THE LINING PANELS
Becton 7 only. The lining panels supplied are to be installed into the fire before the coal matrix is fitted. Note: The lining panels are reversible (brick or plain pattern)
Ensure the appliance is cold.
With the fire door open, the glass retaining frame and the coal set removed, proceed as follows:
Do not force the linnings into position.
1.Position the rear lining face down at the rear of the fire. Ensure the cutout faces the rear of the fire.
Fig. 3a Positioning the rear lining
2.Locate side lining in the right hand side of the fire. First position the tall edge into the radius at the front of the fire.(See Fig.3b below)
Fig. 3b Fitting the R/H side lining
3.Then rotate the rear edge until the top faces match up the angle faces at the rear of the fire. (See Fig. 3c) Repeat exercise for the left hand side.
Fig. 3c Fitting the side linings
4. Rotate the rear lining to bring it vertical (Fig. 3d)
Fig. 3d Rotating the rear lining
5.Centre the assembly. Line up each end of the rear lining with the edges of the fixed matrix plate. (See Fig. 3e)
Fig. 3e Liner panels assembled in the fire.
Once the lining panels are fitted, arrange the coals. See “Arranging the coals” on page 8.
Becton Bunny & Becton 7 mk3 Gas stoves | 7 |