Aarrow Fires Becton Bunny, Becton 7 mk3 Servicing Burner Assembly, Regular Service

Page 20

SERVICING

BURNER ASSEMBLY

To remove the burner assembly proceed as follows;

Ensure the appliance is cold.

Step 1 Turn off the gas supply at the gas service cock.

Step 2 Disconnect the supply inlet pipe at the rear of the fire.

Step 3 Open door and remove the glass frame and glass gasket assembly.

Step 4 Remove the coal set and fire box linings.

Step 5 Remove the matrix location plate. Undo the three retaining nuts and lift out.

Step 6 Remove the heat shield. Undo the two retaining nuts located on the left hand side of the shield. Slide the shield backwards and lift out carefully. Do not damage the covering.

Step 7 Remove the gas valve control knob. Pull off.

Step 8 Remove the 15mm retaining flange nut. 17mm socket.

Step 9 Remove two off posi-drive screws just inside the fire door aperture.

The burner assembly will now lift out.

After replacement of burner assembly, ensure that a check on the gas tightness of any new joint is carried out.

REGULAR SERVICE

See "SAFETY NOTICES" ref coal set page 4.

Any soot debris should be removed from the fuel bed regularly by the end user.

Ensure the appliance is cold.

Step 1 Isolate the gas supply from the fire.

Step 2 Open the fire door and remove the glass frame and the glass/gasket assembly (Note the fire door is secured with a magnet).

Step 3 Carefully remove and clean the coal set of any soot deposits with a soft a brush.

Step 4 Remove any soot deposits from inside the fire using a vacuum cleaner.

(See “Safety Notices” under ‘Coal set’ on page 4).

Step 5 Replace the coal set. See assembly procedure on page

Step 6 Replace glass/gasket assembly and glass frame.

Step 7 Close fire door.

20

Becton Bunny & Becton 7 mk3 Gas stoves

Image 20
Contents Becton MK Flaming Good Fires Contents InstallationGeneral Information Safety NoticesIntroduction Certification Introduction Important NoticesStatutory Requirements Operating Instructions Technical Data Fire DimensionsMax. Heat Setting Min. Heat SettingOperating Instructions Fitting the Lining Panels Positioning the rear liningSafety Notice Please see Safety Notices ref. Coal set Operating Instructions Arranging the CoalsOperating Instructions Lighting & Controlling the Fire Operating Instructions Installation Installing the Fire Fitting the FeetFlue System Nacs National Association of Chimney Sweeps telephone 01785See c See dFire Location Graph 1.Combustible Shelf Clearances Test Sequence Installation Hearth RequirementsConnecting the GAS Supply Installation Fire Testing Flame failure device testingChecklist Installation Check ListServicing Detail of Pilot Assembly Fire Door Glass & Seal Replacement of the Door Trim Servicing Door TrimEnsure the appliance is cold Lifting the door off its hingesServicing Burner Assembly Regular ServiceServicing Annual Service Cleaning Outer SurfacesCleaning the Glass See Safety Notices ref coal setFault Diagnosis ServicingAdd on Canopies Accessories and OptionsSpare Parts General Components Becton Bunny & Becton 7 mk3 Gas stoves Becton Bunny & Becton 7 mk3 Gas stoves Spare Parts Visual Aid Bunny Becton Part DescriptionControl Door Handle Assembly AFGS1085 AFGS080 AFGS080Becton 7 mk3 Lining Kit AFGS1072 AFGS025Guarantee Customer RegistrationService Record Date of Visit Company Work Carried Out SignatureBecton ’ve checked it and it’s O.K Final Factory Check List