APPENDIX A
MAINTENANCE
Caution: Turn off gas and electrical power supply (if appli- cable) and allow ample time for unit to cool before servicing appliance. It is recommended that the fi replace and its vent- ing should be inspected at least once a year by a qualifi ed service person.
Glass Panel:
Warning: Do not operate fi replace with glass panel removed, cracked or broken. Replacement of the glass panel should be done by a licensed or qualifi ed service person.
Do not strike or otherwise impact the glass in anyway that may cause it to break. If the glass becomes cracked or broken, it must be replaced before using the fi replace. Replacement glass can be obtained from your nearest Town and Country FireplacesTM dealer. The size required is 36" x 30" x 5mm. Use ceramic glass only. Do not substitute with any other type.
To remove broken glass, remove window frame as noted in "Window Frame Removal" section.
Unclip the Glass Retainer Clips located at the top of the Win- dow Frame. Pull the top edge of the glass out of the frame fi rst, then lift it up and out of the bottom edge.
Install the new piece of glass with the gasket into the frame so that the thicker bead of gasket faces the fi replace.
Fig. # 34 | ELECTRONIC PILOT |
| PILOT FLAME |
FLAME SENSOR |
|
| ELECTRODE |
Annual Inspection:
a)Remove glass panel and log set. Inspect logs and burner assembly for soot buildup. If excessive buildup of soot is present, have a qualified service person inspect and adjust unit for proper combustion. Clean logs and burner with a brush or vacuum cleaner, paying close attention to burner ports.
b)Check the pilot system for proper fl ame size and opera- tion. Clean pilot free of soot, dust or any other deposits. (See Fig. #35 and 36)
c)Check that the vent pipe and vent terminal are open and free from blockage or debris. If the venting is disassembled for cleaning, it must be properly assembled and
d)Check glass panel gasket, replace if necessary. It is important that the glass seal be maintained in good condition.
e)Check and replace batteries as needed.
Note: The appliance area must be kept clear and free from combustible materials, gasoline and other fl ammable vapours and liquids.
Periodically:
a)Viewing glass may be cleaned as necessary with fi replace glass cleaner.
b)Exterior fi nish may be cleaned with mild soap and water.
CAUTION:
Do not use abrasive cleaners on glass or any other part of the fireplace.
Do not clean glass when hot.
| MILLIVOLT PILOT |
Fig. # 35 |
|
THERMOPILE | THERMOCOUPLE |
PILOT FLAME
ELECTRODE
36ARB2 25 |