PGS TC36 AR manual Installation Requirements, TOP Standoffs, Locating the Fireplace

INSTALLATION REQUIREMENTS

The Town & Country Fireplace installation and venting must conform to the current CAN/CGA-B149 installation code (in Canada) or the current National Fuel Gas Code, ANSI Z223.1 (in the USA), and approved per local codes. Only qualified (licensed or trained) personnel should install this product.

In the state of Massachusetts, only a licensed Plumber and Gas Fitter may install this product.

Fig. # 4

TOP

STANDOFFS

TOP STANDOFFS

The top standoffs are shipped loose inside the fi replace and must be installed on top of the fi replace as shown in fi g. #4. Do this once the fi replace is on site and in position.

LOCATING THE FIREPLACE

In planning the installation for the fi replace, it is necessary to determine where the unit is to be installed, location of vent system and where gas supply piping may be plumbed. Vari- ous installations are possible, such as, into an existing wall, a corner, a built-in wall or a wall projection (see Fig. #5). Due to high temperatures, do not locate this fi replace in areas of high traffi c or near furniture or draperies.

The minimum clearances from the fireplace to combus- tible surfaces must be adhered to and are shown on Fig.

# 2 and 3.

Fig. # 5

SEE FIG #9 FOR DIMENSIONS

Examples of Common Locations

CAUTION: When selecting a location, ensure that there is adequate room on the right hand or left hand side of the fi replace for the control box.

050505-36 36ARB2 5