MAINTENANCE
4)Remove the two outside frame pieces by removing two screws per side. See dia- gram below.
5) At this point you should disconnect the gas at the valve. You can access it through the front now that the control panel is off, or you can access it through the rear pedestal cover plate.
6)Carefully remove the logs and embers.
7)Remove burner. See diagram below.
Note: Use a magnetic type screwdriver if possible.
8)Remove all 18 screws holding the burner tray assembly in place.
9)Carefully lift the burner tray assembly out. Be careful not to tear gaskets when lifting out the valve tray; these gaskets seal the valve from the exterior of the firebox.
10)To replace the burner tray assembly, sim- ply reverse these instructions.
U37 Regency ULTIMATE Rear Vent Direct Vent Freestanding Gas Heater | 27 |