Info Page: Clean Trg. 1
This page shows the current settings for the time based and externally activated forced draining/box cleaning (MHTC Reflow) or the box cleaning (MHTC Flow), respectively.
Note: Wash = draining with simultaneous box cleaning (MHTC Reflow) or box cleaning only (MHTC Flow), Drain = draining only.
–Time controlled draining/box cleaning (Timer).
–Actual time of day.
–Point in time of the next draining/cleaning cycle.
–Configured cleaning mode.
–Interval controlled draining/box cleaning (Periodic).
–Configured interval time in hours.
–Remaining time in hours up to the next draining/cleaning cycle.
–Configured cleaning mode.
–Externally controlled draining/box cleaning (Demand).
–Actual status of the draining/cleaning demand.
–Configured cleaning mode.
–Clean Trg. 1 deactivated (can appear only with module MHTC Flow).
Info Page: Clean Trg. 2 (Note: This page is not shown with model MHTC Flow)
–Fill cycle controlled draining (Cycle).
–Number of fill cycles between cleaning/draining cycles.
–Remaining fill cycles up to the next draining.
–Cleaning mode (Wash= Draining with simultaneous box cleaning or box cleaning only, Drain= draining only).
–Conductivity controlled draining/cleaning (µSensor)
–Set conductivity limit value inn µS/cm.
–Actual conductivity value of the water in the tub in µS/cm.
–Configured cleaning mode.
–
10-00
Page 7